Porter Cable 314 Manual De Instrucciones página 11

TO ADJUST FOR BEVEL CUTS
Loosen the front (A) Fig. 2 and rear (B) Fig. 2 angle-adjusting knobs. Tilt the saw
housing until the desired graduation mark (C) lines up with the indicating line (D)
Fig. 3 on the depth-adjusting bracket. Firmly tighten the knobs to hold the saw in
the selected position.
A
TO ATTACH THE BASE INSERT
The base insert is used to reduce chipping and splintering of the top fibers of
plywood and paneling when used in conjunction with a fine tooth blade. When
the base insert is used. You can cut either side (finished our unfinished) of the
workpiece.
NOTE: Do not use this insert when making bevel cuts.
Adjust the saw for the minimum depth-of-cut. Place the slot of the insert around
the stud (A) Fig. 4 on the front of the saw base. Install a flat washer and thumb nut
to the stud loosely. Adjust the saw for the desired depth of cut, and align the insert
so that the saw blade is centered in the slot in the insert. Tighten the thumb nut
firmly.
TO ATTACH THE RIP GUIDE
Adjust the saw for the minimum depth-of-cut. Place the slot in the rip guide over
the stud (A) Fig. 5 on the front of the saw base.
Install a flat washer and thumb nut on the stud loosely. Adjust the guide to the
desired width-of-cut. Take into consideration the blade thickness and set. Tighten
the thumb nut firmly.
A
Disconnect the tool from the power source!
B
Fig. 2
Disconnect the tool from the power source!
Disconnect the tool from the power source!
Fig. 4
C
11
D
Fig. 3
A
Fig. 5