DeWalt PRESSUREADY DXPW3400PR Manual De Instrucciones página 15

3. Ensure the engine ON/OFF switch
OFF position.
Fig. K
ON
4. Place the fuel valve lever in the ON position.
Fig. L
5. Connect the water hose to the cold water source. Turn
the water source on to remove all air from the hose
and flush any debris. When a steady stream of water is
present, turn the cold water source off.
6. Verify the filter screen
filter is not flat, convex side should face out.
NOTICE: Failure to use an inlet screen filter may cause
damage to pump components and void warranty.
Fig. M
7. Connect the cold water source
NOTE: Water source must provide a minimum of 5
gallons per minute at 20 psi (138 kPa). NOTE: The
pressure washer will not start in PRESSUREREADY®
system mode with low water flow.

WARNING: To reduce the possibility of contamination
always protect against backflow when connected to a
potable water system.
8. Connect high pressure hose
Fig. N
15
9. Attach high pressure hose
is secure. See Assembly.
10. Connect wand 5 to spray gun. Make sure connection
is secure. See Assembly.
27 in the
OFF
27
ENgiNE
14 is in water inlet of pump. If the
14
15 to pump inlet.
9 to pump outlet.
9 to spray gun. Make sure it
11. Connect the QC nozzle to the spray wand. Choose the
correct nozzle for the job to be performed, see Spray
Wand Nozzles. If applying a chemical/cleaning soap,
refer to Chemicals/Cleaning Soaps.
12. Turn the cold water source on.
NOTICE: Risk of property damage. Failure to do so
could cause damage to the pump.
13. Remove all air from the pump and high pressure hose
by squeezing the spray gun trigger for approximately
30 seconds or until a steady stream of water is present.
Release the spray gun trigger.
14. Install the battery pack:

WARNING:
• Make certain the engine ON/OFF switch is in the
OFF position to prevent switch actuation before
removing or installing battery.
• DO NOT insert/remove battery while engine
is running.
ONLY USE D
•
any other battery will void the warranty.
NOTE: For best results, make sure your battery pack is
fully charged.
Open battery housing cover: Push the spring lock
-
down (1) to unlock the cover and pull cover up to
open (2).
Fig. O
To install battery pack: Insert battery pack
-
into battery housing
fully seated and an audible click is heard. Make
sure battery pack is fully seated and fully latched
into position.
- Close and lock the battery housing cover.
- The green, yellow, and red light on the
PRESSUREADY® control box should illuminate
momentarily and then turn off. The blue light on the
ON/STOP button should be flashing.
Fig. P
9
WALT rechargeable batteries, use of
e
12 as shown in Fig. P until
24
ENgLish
23
12
23
13