DeWalt PRESSUREADY DXPW3400PR Manual De Instrucciones página 13

NOTICE: DO NOT attempt to increase pump pressure.
A higher pressure setting than the factory set pressure
may damage the pump.
Fig. G
Spray Wand Nozzles (Fig. A, H)
The nozzles for the spray wand are stored in the nozzle
holder 2 on the panel assembly
identify nozzle location and spray pattern. Refer to the
following chart to choose the correct nozzle for the job to
be performed.
Nozzle spray Pattern
Color
0˚
Red
15˚
Yellow
˚
25
green
˚
40
White
low pressure
Black
*** NOTICE: The high pressure spray from your pressure
washer is capable of causing damage to surfaces such
as wood, glass, automobile paint, auto striping and
trim, delicate objects such as flowers and shrubs. Before
spraying, check the item to be cleaned to assure yourself
that it is strong enough to resist damage from the force
of spray.
Changing Nozzles on Spray Wand (Fig. H)

DANGER: Risk of fluid injection. Do not direct
discharge stream toward persons, unprotected skin,
eyes or any pets or animals. Serious injury will occur.
30
1 . Colors on the panel
Uses surfaces***
powerful metal or concrete;
pinpoint for
DO NOT use on
very intense
wood
cleaning
intense metal, concrete or
cleaning of wood
small areas
intense metal, concrete or
cleaning of wood
larger areas
covers wide metal, concrete,
areas of wood or vinyl
cleaning
applies metal, concrete,
chemical/ wood or vinyl
cleaning
soaps

WARNING: Flying objects could cause risk of serious
injury. DO NOT attempt to change nozzles while
pressure washer is running. Turn engine off before
changing nozzles.
1. Pull quick-connect coupler back and insert nozzle.
2. Release quick-connect coupler and twist nozzle to make
sure it is secure in coupler.

WARNING: Flying objects could cause risk of serious
injury. Ensure nozzle is completely inserted in quick-
connect socket and quick- connect collar is fully
engaged (forward) before squeezing spray gun trigger.
Fig. H
Chemicals/Cleaning Soaps
Applying chemicals or cleaning soaps is a low
pressure operation.
NOTE: Use only chemical and cleaning soaps designed for
pressure washer use. Do not use bleach.
To Apply Chemical/Cleaning Soaps (Fig. I)
1. Press chemical/soap hose
located near high pressure hose connection of pump
as shown.
Fig. I
2. Place the other end of chemical/soap hose with filter
into the container holding the chemical/cleaning soap.
NOTE: For every 10 gallons (38 liters) of water pumped
1 gallon (3.8 liters) of chemical/cleaning soap will
be used.
3. Install low-pressure (black) nozzle into quick connect
fitting of spray wand, refer to spray Wand Nozzles.
NOTE: Chemical/cleaning soaps will not siphon if the
black soap nozzle is not installed on the spray wand.
4. After use of chemical/cleaning soaps, place
chemical/soap hose into container of clean water and
draw clean water through chemical injection system to
rinse system thoroughly.
NOTICE: Risk of property damage. Failure to do so
could cause damage to the pump. Pumps damaged
due to chemical/cleaning soaps will not be covered
under warranty.
ENgLish
26 onto barbed fitting
26
11