Storage Recommendations - DeWalt PRESSUREADY DXPW3400PR Manual De Instrucciones

ENgLish
is no battery pack in the cavity. Unplug the charger
before attempting to clean.
6. Do not freeze or immerse the charger in water or any
other liquid.

Storage Recommendations

NOTICE: DO NOT store battery pack in pressure
washer. ALWAYS turn unit off and remove the battery
pack before storing.
1. The best storage place is one that is cool and dry, away
from direct sunlight and excess heat or cold.
2. For long storage, it is recommended to store a fully
charged battery pack in a cool dry place out of the
charger for optimal results.
NOTE: Battery packs should not be stored completely
depleted of charge. The battery pack will need to be
recharged before use.
SAVE THESE INSTRUCTIONS FOR FUTURE USE
ASSEMBLY
Pressure Washer Assembly (Fig. A, C–F)
1. Slide the handle assembly
secure with saddle bolts
Fig. C
8
6
2. Align holes in the top handle
holes in the handle assembly
through aligned holes and secure top handle to handle
assembly with knobs

CAUTION: Risk of personal injury. Avoid placing
hands between handle and frame when assembling
to prevent pinching.
3. Attach high pressure hose
it is secure.
Fig. D
4. Connect wand 5 to spray gun
is secure.
10
8 onto the frame 6
20 and knobs 21 .
22
8
21
21
20
22 with the mounting
8 . Insert saddle bolts
21 . Tighten until snug.
9 to spray gun 3 . Make sure
3
9
3 . Make sure connection
5. Remove the five colored quick-connect nozzles from the
plastic bag and insert them into correct grommet on the
nozzle holder. Nozzles are color coded to match colored
nozzles on panel assembly.
6. Check the tire pressure and add air if needed.
NOTE: Air tanks, compressors and similar equipment
used to inflate tires can fill small tires similar to these
and
very rapidly. Adjust pressure regulator on air supply to
no more than the rating of the tire pressure. Add air in
small increments and frequently use the tire gauge to
prevent over inflation.

WARNING: Risk of bursting. Use a tire pressure gauge
to check the tires pressure before each use and while
20
inflating tires; see the tire sidewall for the correct
tire pressure.
OPERATION
Pressure Adjustments
The pressure setting is preset at the factory to achieve
optimum pressure and cleaning. To lower the pressure,
20
follow these instructions.
1. Back away from the surface to be cleaned. The further
away the nozzle is, the less the pressure will be on the
surface to be cleaned.
2. Change to the 40˚ nozzle (white). This nozzle delivers a
less powerful stream of water and a wider spray pattern.
Refer to spray Wand Nozzles.
3. This pressure washer's high pressure pump is equipped
with an adjustable unloader
allows the pressure setting to be adjusted. To lower the
pressure, turn the pressure control knob on the pump
counterclockwise to the desired pressure. To return the
pump pressure to the factory setting, turn the pressure
control knob on the pump clockwise until it stops.
NOTICE: DO NOT try to turn pressure regulator
knob past the built-in stop or damage to the pump
will result.
NOTICE: DO NOT overtighten the pressure control
knob. If overtightened the knob COULD break and
result in immediate loss of water pressure and costly
repairs to the unit.
Fig. E
3
Fig. F
30 (Fig. G) feature that
5