Denon AVC-A1SR Instrucciones De Operación página 17

[2] Power amplifier assignment function setting
Make this setting to switch the power amplifier for the surround back channel to Multi-zone2.
1
At the System Setup Menu, select "Multi Zone Control".
2
Press jog stick "ENTER" to switch to the "Multi Zone
Control" screen.
3
Select "Power Amp Assignment" then press jog stick "ENTER".
4
Select "Surround Back" to use as the
surround back channel, "Zone2" to use as
multi-zone2, then press jog stick "ENTER".
Setting the Auto Surround Mode
The surround mode last used for the four types of input signals shown below is stored in the memory and the
signal is automatically played with that surround mode the next time it is input.
Note that the surround mode setting is also stored separately for the different input sources.
q Analog and PCM 2-channel signals
w 2-channel signals of Dolby Digital, DTS or other multichannel format
e Multichannel signals of Dolby Digital, DTS or other multichannel format
r Multi-channel signals when playing sources using the EXT.IN-1, EXT.IN-2 and DENON LINK terminals
During playback in the PURE DIRECT mode, the surround mode does not change even if the input signal
changes.
1
Select "Auto Surround Mode" on the System
Setup Menu screen, then press jog stick
"ENTER".
2
Select "ON" if you want to use the auto surround mode,
"OFF" if you do not want to use it.
When "Surround Back" is selected When "M-ZONE2" is selected
3
Enter the setting.
The System Setup Menu reappears.
Setting the Ext. In Setup
• Set the method of playback of the analog input signal connected to the Ext.In-1 and Ext.In-2 terminal.
1
At the System Setup Menu select "Ext.In Setup".
2
Switch to the Ext.In Setup screen.
3 q Select the input terminal.
4
Select the item to be set (push the jog stick
to the up and down) then select the
parameter (push the jog stick to the left and
right).
MODE:
DSP: The analog input signal is converted into a digital signal and undergoes DSP processing.
System Setup settings (speaker configuration, channel delay, etc.) are reflected in the
same way as for other input signals.
ANALOG: The analog input signal is played without DSP processing.
SW and center channel: Down-mixing is conducted by the analog circuit. Surround and
surround back channels: Not output if "No" is selected at the speaker configuration.
Channel delay: Not reflected.
S.Back:
Set when MODE is set to DSP. Select according to the specifications of the player being used. Also refer
to the player's operating instructions.
NOT USE: Select when neither SBL or SBR is connected.
SB (SBL): Select when only one surround back channel (SBL) is connected.
SBL/SBR: Select when two surround back channels (SBL and SBR) are connected.
SW Level:
Select according to the specifications of the player being used. Also refer to the player's operating
instructions.
+15 dB (default) recommended. 0, +5, +10 and +15 dB selectable.
INPUT Vol.:
Set when MODE is set to DSP.
If the OVER LOAD indicator is displayed on the fluorescent tube, adjust the input level to between 0 and
-20 dB.
ENGLISH
w Switch to the setting screen.
17