HEIDENHAIN EIB 700 Serie Manual De Instrucciones De Uso página 26

Operating Instructions en
4.4 Connecting encoders
NOTICE
If the supply voltage range or the wiring is incorrect,
there is a hazard of damaging the product and the
encoder!
Note the supply voltage range of the connected
encoder.
Verify that the connecting cable between the encoder
and the product is correctly wired.
Do not engage or disengage the connecting cable
between the encoder and the product while under
power.
The connection of non-HEIDENHAIN encoders to the
product and the operation of the product with non-
HEIDENIAN encoders are at the user's own risk.
Connections
Encoders with 15-pin interfaces are connected to the
encoder inputs X11 to X14 provided on the front panel.
For information on the location of the connections, see
"Product overview", page 26.
For more information on the connections, see
"Specifications", page 35.
Information on the pin layout of the EnDat and 1
V interface:
PP
Cable shield connected to housing
Sensor: The sensor line is connected internally
with the corresponding power line.
EnDat interface
Pin Function
1, 3, 7 , 9, 11, 14 Incremental signals (only with ordering
designations EnDat 01 and EnDat 02)
2, 4, 10, 12 Power supply
5, 8, 13, 15 Position values
6 Internal shield
For EnDat signal assignment, see "L".
28
1 V interface
PP
Pin Function
1, 3, 7 , 9, 11, 14 Incremental signals
2, 4, 10, 12 Power supply
5, 8 *) , 13, 15 *) Signal assignment of pin 8 varies de-
pending on support by firmware (see
User's Manual for Application Develop-
ment):
Homing
L1 only for LIDA 4xx, for example
H only for LIF 481, for example
6 Signal assignment varies depending on
support by firmware (see User's Manu-
al for Application Development):
Limit
L2 only for LIDA 4xx, for example
L only for LIF 481, for example
For 1 V signal assignment, see "L".
PP
Connecting the encoder cables
Connect the cables of the encoders tightly to the
respective connections on the rear panel.
If the cable connectors include mounting screws, do not
overtighten them.
Vacant pins or wires must not be used.
EIB 700