OPERATING AND MAINTENANCE MANUAL
POOL ELECTRIC PUMP POOL SERIES
2. GENERAL
ENG
•
These instructions are for correct installation and optimum pump performance and should be
read carefully.
•
These are single-stage centrifugal pumps designed to operate with compact swimming pumps.
•
They are equipped with a total draining system to prevent the discharge of residual liquid at each
stop.
•
These units are designed to operate with clean water at a maximum water temperature of 50 C.
•
Constructed with high quality materials, they are subject to strict hydraulic and electrical controls
and are carefully checked.
•
Correct installation is ensured by following these instructions and those in the wiring diagram,
otherwise overloading of the motor may occur. We disclaim liability for any damage caused by
failure to follow these instructions.
•
The benchmark for the most efficient water pumps is MEI 0.70.
•
The efficiency of a pump with a trimmed impeller is usually lower than that of a pump with the
full impeller diameter. Trimming the impeller will adapt the pump to a fixed duty point, which will
reduce energy consumption.
•
The Minimum Efficiency Index (MEI) is based on the full impeller diameter. The operation of this
water pump with variable duty points can be more efficient and economical when controlled, for
example, by using a variable speed drive that matches the pump's duty with the system.
3. INSTALLATION
Pumps should be installed horizontally, secured with screws through the holes in the brackets to avoid
undesirable noise and vibrations.
The suction; pump piping should be as short as possible.
The rating label must be visible after installation. Parts containing live parts, except parts supplied with
extra low safety voltage <12V, must be inaccessible to a person in the pool.
For Class I devices that do not have a plug, they must be permanently connected to fixed wiring. The part
including electrical components, except remote control devices, must be located or repaired.
8