Data Rating Label Location; Burner Testing - Thermador Professional Pro Grand Serie Manual De Instalación

3. Repeat with the remaining kick panel screws, assuring
kick panel is level.
• The range kick panel should maintain a minimum
½'' (12.7 mm) clearance above the floor.
Installing the leg covers, Pro Grand models
1. Remove plastic coverings from the stainless steel
covers.
2. Beneath the range, wrap the foot cover assembly
around the leg. Insert the foot cover tabs into the tab
slots, as shown.
3. Repeat for all visible legs.
• If additional leg covers are required, they may be
ordered from Customer Support by calling
1-800-735-4328 at no charge for up to one year
after purchase date of the appliance.

Data rating label location

The data rating label shows the model and serial number
of your appliance. Depending on your model, the data
rating labels are located above the main oven or behind
the kick plate.
Electric wiring diagrams and schematics
The electric wiring diagrams and schematics are attached
behind the toe kick, and should not be removed except by
a service technician, then replaced after service.

Burner testing

9 WARNING
To prevent flare-ups and avoid the creation of harmful by-
products, do not use the cooktop without all burner caps
and all burner grates properly positioned.
9 WARNING
To prevent burns, do not touch burner caps or grates
while hot. Turn the cooktop off and allow the burners to
cool.
Install any loose components, such as burner caps and
grates that may have been removed earlier. Be certain that
burner caps seat properly into the burner bases. Before
testing operation of the appliance, verify that the unit and
the gas supply have been carefully checked for leaks and
that the unit has been connected to the electrical power
supply. Turn the manual gas shut-off valve to the open
position.
The burner caps must be properly placed on the burner
bases for the cooktop to function properly. If the burner
cap is not properly placed, one or more of the following
problems may occur:
• Burner flames are too high.
• Flames shoot out of burners.
• Burners do not ignite.
• Burner flames light unevenly.
• Burner emits gas odor.
To place the burner caps
Each cap has a letter (B, D, or F) cast in the underside of
the cap that corresponds to a letter (B, D, or F) cast in the
burner base that is attached to the appliance.
20