GET ECULMB RACE KIT Guia De Instalacion página 8

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 20
ATTENTION: The minimum value is saved if similar
to the OE one, otherwise GET ECULMB will discard
the value because it will read it as incorrect. It is not
possible to manage the maximum value.
It is possible to carry out the ZERO TPS Calibration with or
without GET WiFi-COM (included in the kit).
ATTENTION: REMEMBER TO WORK UNDER SAFETY
CONDITIONS AND TO KEEP THE ENGINE TURNED OFF.
ZERO TPS CALIBRATION – without GET WiFi-COM
1. Twist the throttle completely forward to make sure it is in
closed position during this operation. Set the emergency OFF
switch in "run" position.
2. Remove the protection cap from the motorbike's diagnostic
connector and connect the Wake-up connector (included
as part of the OE motorcycle's separate enclosure). The OE
diagnostic connector can be found near the motorcycle battery:
check on the workshop manual where to find it.
3. Press and hold the switch off button for 10 seconds. By doing
this operation, the minimum TPS value is saved.
4. Remove the "Wake-up connector" to avoid discharging the
bike battery.
ZERO TPS CALIBRATION – with GET WiFi-COM
To set Zero TPS, open WiGET
app
and
select
"MONITOR"
section. Follow the instruction
in
GET
WiFi-COM
manual,
included in the kit, and look at
WiGE T video tutorial (minute
5:55). Scan the QR code.
EN
14
If the engine doesn't start after the TPS calibration:
1. Uninstall GET ECULMB.
2. Install the OEM EFI back and resume the factory engine idle.
3. Uninstall again the OEM EFI and re-install GET ECULMB.
4. Repeat step 1, 2, 3 of "Idle regulation" and step 1, 2, 3, 4 of
"Zero TPS Calibration – without GET WiFi-COM".
IMPORTANT WARNING:
After KTM & HUSQVARNA updates on OEM EFI
calibration and idle screw setting, GET released a new
firmware (FW) and map for the new configurations.
You can always find the updated maps and firmware
on athena.eu. To install the firmware update, it is
necessary to use GET Maya Software.
To verify if it is necessary to update your ECULMB firmware or if
you need to modify the idle screw setting, check GET ECULMB
firmware with GET WiFi-COM provided in the kit. Open the menu
in WiGET app, select "SYSTEM INFO" and check the value "Fw
Code", which is the firmware code of the connected GET ECULMB.
Perform the firmware update and/or the idle screw setting
accordingly to the scheme below:
Not necessary
Necessary
MY 2018 FW Code:
Before MB2TPI10 (e.g. MB2TPI09)
MY 2018 FW Code: Equal or after
MB2TPI10 (e.g. MB2TPI11)
MY 2019 FW Code:
Before MB2TPI10 (e.g. MB2TPI09)
Update
Idle screw
FW
setting
15
EN
Tabla de contenido
loading

Este manual también es adecuado para:

EculmbEculmb efi 2t ecu

Tabla de contenido