Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Installing or removing the tilt base
Optional accessory
1.
Open the lock lever of the tilt base, then insert the
tool into the tilt base aligning the groove on the tool with
the protrusion on the tilt base.
2.
Close the lock lever.
Fig.14
► 1. Lock lever
To remove the base, follow the installation procedure
in reverse.
Installing or removing the offset
base
Optional accessory
1.
Press the shaft lock, then loosen the collet nut.
1
2
Fig.15
► 1. Collet nut 2. Shaft lock 3. Wrench
2.
Remove the collet nut and the collet cone.
Fig.16
► 1. Collet nut 2. Collet cone
1
3.
Install the pulley onto the tool by pressing the
shaft lock and tightening the pulley with the wrench.
Fig.17
► 1. Wrench 2. Pulley 3. Shaft lock
4.
Loosen the screws on the base plate, and then
remove the base plate.
3
Fig.18
► 1. Base plate
10 ENGLISH
1
2
1
2
3
1
Tabla de contenido
