Optional Accessory - Makita DUH501 Manual De Instrucciones

10. Align the holes on the shear blades with the holes
on the tool, and then tighten 2 screws to fix the shear
blades.
1
► 1 . Screw 2. Hole
11. Attach the rod.
2
► 1 . Rod 2. Small hole
NOTICE:
Apply a small amount of grease to the
inner periphery of the small hole of the rod.
NOTICE:
Make sure that the protrusion on the
shear blades fits in the small hole on the rod.
12. Attach the plate.
► 1 . Protrusion 2. Plate
NOTICE:
Make sure that the protrusion on the
shear blades fits in the hole on the plate.
2
1
1
2
13. Attach the cover, and then tighten 6 screws.
► 1 . Cover 2. Screw
NOTICE:
Be sure to attach 2 long screws to the
center holes.
NOTICE:
If the shear blades do not move
smoothly, the shear blades are not engaged with
the rods properly. Install the shear blades again.
NOTICE:
If the parts other than the shear blades
such as the rods are worn out, ask Makita Authorized
Service Centers for parts replacement or repairs.
Installing or removing the chip receiver

Optional accessory

CAUTION:
When installing or removing the
chip receiver, always wear gloves so that your
hands do not directly contact the shear blades.
NOTICE:
The blade cover cannot be installed if the
chip receiver is installed on the tool. Before carrying
or storing the tool, uninstall the chip receiver, and
then install the blade cover to avoid blade exposure.
NOTICE:
Be sure to remove the blade cover
before installing the chip receiver.
The chip receiver gathers discarded leaves and makes
clean-up afterward much easier. It can be installed on
either side of the tool.
To install the chip receiver, align the tip of the shear
blades with the tip of the chip receiver, and then press
the chip receiver against the shear blades so that the
hooks fit into the grooves on the shear blades.
► 1 . Hook
11 ENGLISH
1
1
1
2