Makita GTR01 Manual De Instrucciones página 18

1. Loosen the clamp screw, then install the trimmer
guide on the trimmer base, and then tighten the clamp
screw.
Fig.56
► 1. Clamp screw
2. Loosen the clamp screw and adjust the distance
between the trimmer bit and the trimmer guide by turn-
ing the adjusting screw (1 mm (3/64") per turn). At the
desired distance, tighten the clamp screw to secure the
trimmer guide.
1
2
Fig.57
► 1. Adjusting screw 2. Clamp screw
3.
Move the tool with the guide roller riding the side
of the workpiece.
1
Fig.58
► 1. Workpiece 2. Trimmer bit 3. Guide roller
1
2
3
18 ENGLISH
Using the tool with the tilt base
The tilt base is used for trimming the edge of laminate
sheet or similar materials.
The tilt base is convenient for chamfering. Loosen the
wing screws, then tilt the tool at the desired angle, and
then tighten the wing screws.
Firmly clamp a straight board to the workpiece and use
it as a guide against the tilt base. Feed the tool in the
direction of the arrow.
Fig.59
► 1. Wing screw
Using the tilt base plate with the
trimmer base
To use the trimmer base with a square base plate,
remove the base plate from the tilt base, and then
attach it to the trimmer base.
Fig.60
► 1. Tilt base plate 2. Trimmer base plate
NOTICE:
Use screws on the trimmer base when
installing the tilt base plate. The screws on the
tilt base are shorter than the screws on the trimmer
base.
1
1 2