DeWalt DCFS950 Manual De Instrucciones página 13

Fig. H
12
3. Drop staple strips into the loading slot of the magazine,
making sure the staple heads align correctly with
the slot opening. (Refer to Staple Specifications to
determine compatible size.)
4. Keeping fingers clear of the track, close the magazine by
releasing the pusher latch. Carefully allow the latch to
slide forward and engage the staple strip.
Unloading the Tool

WARNING: The trigger lock-off should always be
locked off whenever any adjustments are made or
when tool is not in use.
1. Slide the spring-loaded pusher to the base of the
magazine to lock it into place.
2. Tip the tool up until the fastener strip slides freely out of
the magazine.
3. With battery removed, check the nosepiece to verify
there are no staples remaining.
Power Setting Summary (Fig. I, J)
This stapler is equipped with a tool free power select
switch to adjust the tool for different applications.
3
In the event staples are not driving to depth in power
setting 1, you may have to switch to power 2 or 3 for
additional driving power.
Fig. I
NOTICE: Driving staples into soft materials at
high power settings will cause excessive wear to
your tool and may result in early failures.
Power
Setting

Fig. J
Adjusting Depth (Fig. K)
The depth that the staple is driven can be adjusted using
the tool free depth adjust

1. To drive the staple shallower, rotate the tool free depth
2. To drive a staple deeper, rotate the tool free depth
3
Selecting the Mode (Fig. A)

To select standard sequential mode, slide the tool free mode
select switch
Application
Shorter staple length / minimal
1
staple drive desired
Increased staple drive desired for
2
medium to large staple lengths
3 Maximum staple drive desired
WARNING: Staples must be driven straight into the
material. Do not tilt stapler while driving fasteners.
Refer to Fig. J. Staple retention values improve when
the tool is fired perpendicular to the material.
6 on the nose of the tool.
WARNING: To reduce risk of serious injury from
accidental actuation when attempting to adjust
depth, ALWAYS:
• Remove battery pack
• Engage trigger lock-off.
• Always point the nose of the stapler away
from you.
• Avoid contact with trigger during adjustments.
adjust 6 to the left.
adjust to the right.
6
Fig. K
6
WARNING: Always wear proper eye [ANSI Z87.1
(CAN/CSA Z94.3)] and ANSI S12.6 (S3.19) hearing
protection when operating tool.
to display the single arrow icon.
4
English
Typical Staple Length
1-1/2" (38 mm) typical
1-3/4"–2"
(44.4 mm–51.1 mm) typical
1-3/4"–2"
(44.14 mm–51.1 mm) typical
11