Power Supply; Accumulator Supply - Kaiser+Kraft 614 627 Manual De Uso Y Mantenimiento

Power Supply

6.
6.1

Accumulator supply

Scale on the handpalett KPZ is delivered with the charger. Delivered charger supply the energy to built-in
accumulator.
Charging: Protect the handpallet from moving. When the display is turned off you may proceed and
connect the charger to on-site power supply (230V), other end plug in to the socket located in the front of
the device.
When the charger cable is unplugged, the diode is showing CHARGE.
Green – accumulator charge up to 75%
Red – charging is still in process
After completing the charging process then automatically turn into safe mode. For full charging effect, it
should be proceeded for 18 hours. Charger must be disconnected before activating the handpallet.
Charger:
Always use original KPZ charging device. The use of any other device may cause considerable damage
to the electronics.
Charger should be checked before using for any damages. If the charging device is damaged by accident
or if any other defect exists, please check the output. If the output is affected in any way, immediately
order a new KPZ charging device. Any damage to the charging device/power pack may result in a
reduction or failure of the unit, resulting in most cases damage to the scale.
Accumulator:
It is recommended to charge the accumulator every day over night. This way will be guaranteed correct
charge level indicator through the day.
overcharging the accumulator. Low voltage strain information appears on the display. Accumulator must
be charged straight away. If charging level is to low, scale is switching it self automatically off or it is
impossible to switch it back on.
The charge jack (Lb) is at the front below the indicator on the right side. 1 A securing (Si) is located on
the left side of it. This securing protects the electronics of overcurrent. If it is impossible to switch on the
indicator, please check the securing and change it if necessary.
Charging system with limited voltage strain protects from
From left side next to safety catch is located switch button (Sch) to switch
on and switch off the display and the printer if it is installed.
GB
GB - 8