Idiomas disponibles
Idiomas disponibles
2
ON-SCREEN OPERATING INSTRUCTIONS
Access to the IRIS On-screen Menus
Press ADJUST on the RCU or the local keypad of the projector to
enter the 'Adjustment mode' (please refer to the owner's manual of
the projector). The IRIS path will be displayed in the menu:
K
highlight IRIS by pushing the control stick forward or backward ;
K
press Enter to start up the IRIS menu.
A waning will warn the user to install the projector correctly before
continuing with the IRIS adjustment and to check if the lens cap of the
IRIS camera is removed.
Press ENTER to continue.
IRIS menu
Three items are available in the Iris menu :
K
AUTOCONVERGENCE;
K
IRIS SETUP;
K
IRIS DIAGNOSTICS.
Choose first IRIS SETUP to carry out the SET-UP for the automatic
convergence.
Iris set up has to be done during the first installation of the projector
or when the projector is relocated to another installation position.
Choose AUTOCONVERGENCE after the IRIS SETUP procedure is
finished.
Use IRIS DIAGNOSTICS to check whether the IRIS
normally.
Iris Set-up
Iris set up has to be done during the first installation of the projector
or when the projector is relocated to another installation position.
To enter the IRIS SETUP menu :
K
highlight IRIS SETUP by pushing the control stick forward or
backward;
K
press ENTER .
The IRIS SETUP menu provides an easy to use method to focus the
camera lens and to center the camera. Be careful while handling the
camera as a properly focused camera lens and correctly centered
camera are required for a perfect automatic convergence alignment.
In addition, the IRIS SETUP menu includes also two options :
K
touch-up on source or on timer;
K
auto-alignment at powerup.
2
5975477 IRIS
211196
2
is functioning
On-screen operating instructions
ADJUSTMENT MODE
Select a path from below :
GUIDED
RANDOM ACCESS
INSTALLATION
SERVICE
IRIS
Source 1
é
ê
Select with
or
then <ENTER>
WARNING
<EXIT> to return
RISK OF INCORRECT
ADJUSTMENT OF THE
PROJECTOR
Insure that the projector has
been installed correctly, that the
blankings are adjusted and that
vertical setup pattern is
centered on the screen.
Check that the lenscap is
removed from the camera.
<ENTER> to continue
IRIS
AUTOCONVERGENCE
IRIS SETUP
IRIS DIAGNOSTICS
é
Select with
or
then <ENTER>;
<EXIT> to return
IRIS
AUTOCONVERGENCE
IRIS SETUP
IRIS DIAGNOSTICS
é
ê
Select with
or
then <ENTER>
<EXIT> to return
ê
5
Capítulos
