Tabla de contenido
Idiomas disponibles
Idiomas disponibles
16. To reduce the risk of injury, never place cutting blade
assembly on base without blending jar properly
attached.
17. Always operate blender with lid in place.
18. When blending hot liquids, remove filler-cap of
two-piece lid and close the edge cover opening
intended for pouring. To prevent possible burns: Do
not exceed the 3-cup (710-ml) level. Hot liquids may
push off two-piece lid during blending; therefore,
with the protection of an oven mitt or thick towel,
place one hand on top of the lid, keep exposed
skin away from the lid, and start blending at lowest
speed.
19. Ensure collar on base of blending jar is tight and
secure. Injury can result if moving blades accidentally
become exposed.
20. If the jar should twist or rotate when the motor is
switched on, switch
jar in collar or on blender base.
If the cutting blade assembly locks and will not move, it will
damage the motor. Do not use. Call the toll-free customer service
number for information.
Do not place blending jar in the freezer filled with food or liquid.
This can result in damage to the cutting blade assembly, jar,
blender, and possibly result in personal injury.
(OFF) immediately and tighten
SAVE THESE INSTRUCTIONS!
Other Consumer Safety Information
21. Do not leave blender unattended while it is
operating.
22. Before plugging cord into wall socket, turn the
control to
(OFF). To disconnect cord, turn the
control to
(OFF). Then remove plug from wall
socket.
23. Do not use appliance for other than intended
purpose.
24. Do not place on or near a hot gas or electric burner
or in a heated oven.
25. CAUTION: In order to avoid a hazard due to
inadvertent resetting of the thermal cut-out, this
appliance must not be supplied through an external
switching device, such as a timer, or connected to
a circuit that is regularly switched on and off by the
utility.
26. Operating time cannot exceed 3 minutes for any
accessory or speed setting.
BEFORE FIRST USE: After unpacking blender, wash everything
except blender base in hot, soapy water. Dry thoroughly. Wipe
blender base with a damp cloth or sponge. DO NOT IMMERSE
BASE IN WATER. Care should be taken when handling cutting
blade assembly as it is very sharp.
3
Tabla de contenido
