Ryobi TSS100L1 Manual Del Operador página 24

TO COMPOUND MITER CUT
See Figures 30 - 31.
A compound miter cut is a cut made using a miter angle and
a bevel angle at the same time. This type of cut is used to
make picture frames, cut molding, make boxes with sloping
sides, and for certain roof framing cuts.
To make this type of cut the control arm on the miter table
must be rotated to the correct angle and the saw arm must
be tilted to the correct bevel angle. Care should always
be taken when making compound miter setups due to the
interaction of the two angle settings.
Adjustments of miter and bevel settings are interdependent
with one another. Each time you adjust the miter setting you
change the effect of the bevel setting. Also, each time you
adjust the bevel setting you change the effect of the miter
setting.
It may take several settings to obtain the desired cut. The
first angle setting should be checked after setting the second
angle, since adjusting the second angle affects the first.
Once the two correct settings for a particular cut have been
obtained, always make a test cut in scrap material before
making a finish cut in good material.
 Pull out the lock pin and lift saw arm to its full height.
 Loosen the miter lock handle. Rotate the miter lock handle
approximately one-half turn to the left to loosen.
 Rotate the control arm until the pointer aligns with the
desired angle on the miter scale.
 Tighten the miter lock handle securely.
 Loosen the bevel lock lever and move the saw arm to the
left to the desired bevel angle.
 Bevel angles can be set from 0° to 45°.
 Once the saw arm has been set at the desired angle,
securely tighten the bevel lock lever.
 Recheck miter angle setting. Make a test cut in scrap
material.
 Place the workpiece flat on the miter table with one edge
securely against the fence. If the board is warped, place
the convex side against the fence. If the concave edge
of a board could collapse on the blade at the end of the
cut, jamming the blade. See Figures 38 - 39.
 When cutting long pieces of lumber or molding, support
the opposite end of the stock with a roller stand or with
a work surface level with the saw table. See Figure 32.
All manuals and user guides at all-guides.com
OPERATION
 Align the cutting line on the workpiece with the edge of
 Grasp the stock firmly with one hand and secure it against
 Before turning on the saw, perform a dry run of the cutting
 Grasp the saw handle firmly then squeeze the switch
 Slowly lower the blade into and through the workpiece.
 Release the switch trigger and allow the saw blade to stop
24 — English
COMPOUND MITER CUT
C-CLAMP
saw blade.
the fence. Use the optional work clamp or a C-clamp to
secure the workpiece when possible.
operation just to make sure that no problems will occur
when the cut is made.
trigger. Allow several seconds for the blade to reach
maximum speed.
rotating before raising the blade out of workpiece. Wait
until the electric brake stops blade from turning before
removing the workpiece from miter table.
Fig. 30