Control Panel Components - Westinghouse iGen2200c Manual Del Usuario

COMPONENTS

CONTROL PANEL COMPONENTS

1. Eco Mode: Eco mode minimizes fuel consumption
and noise by adjusting the engine RPM to the
minimum required for the current load.
2. Parallel Operation
Westinghouse Inverter Generator can be connected
for additional power output.
3. USB Ports: Two-port 5V/2.1A USB outlet. Accepts
Type A USB plugs.
4. Low Oil LED: Indicates low oil level. When the oil
level in the crankcase falls below the safe operating
limit, the low oil level indicator will illuminate and the
generator will automatically shut off the engine.
5. Overload LED: Indicates that the generator is
overloaded.
6. Output Ready LED: Illuminates when the generator
is operating normally. Indicates the generator is
producing electrical power at the receptacles.
10 | Westinghouse Outdoor Power Equipment, LLC
4
5
3
7 2
1
12
Outlets:
A compatible
6 7
11 10
7. CO Sensor indicator lights: The CO Sensor
monitors for the accumulation of poisonous carbon
monoxide gas. If increasing levels of CO gas are
detected, the CO Sensor automatically shuts down
the engine.
8. Fuel Switch: Used to turn fuel knob to the run (ON),
choke, or OFF position.
9. 120 Volt AC, 20 Amp Duplex NEMA 5-20R
Receptacle: Receptacle can supply a maximum of
20 Amps.
10. 15 Amp AC Circuit Breaker: Circuit breaker limits
the current that can be delivered through the NEMA
5-20R receptacle to 15 Amps.
11. Overload Reset: The generator inverter will
automatically switch OFF all AC output to protect
the generator if overloaded or if there is a short
circuit in a connected appliance.
12. Ground Terminal: The ground terminal is used to
externally ground the generator.
8
9