Tabla de contenido
Idiomas disponibles
Idiomas disponibles
20
MAINTENANCE
Danger due to electrical voltage! Handling the machine with the power supply up
may result in serious injury or death. Always disconnect the machine from the power
supply before servicing or maintenance work and secure it against unintentional
restart!
The machine is low-maintenance and only a few parts have to be serviced. Nevertheless, any
faults or defects which may affect the safety of the user must be rectified immediately!
•
Before each start-up, make sure that the safety devices are in perfect condition and
function properly.
Check all connections for tightness at least once a week.
•
Regularly check that the warning and safety labels on the machine are in perfect and
•
legible condition.
•
Use only proper and suitable tools.
Only use original spare parts recommended by the manufacturer.
•
20.1
Inspection and maintenance plan
The type and degree of machine wear depends to a large extent on the operating conditions. The
following intervals apply when the machine is used within the specified limits:
Interval
Before start of work or
after every maintenance or
servicing
Weekly
As needed
After 50h (/ 10h)
20.1.1 Adjusting the taper gibs
Too much play in the guideways can be reduced by adjusting the taper gibs. To adjust, turn the
adjustment screw clockwise. This pushes the taper gibs backwards and reduces the clearance of
the respective guideway.
HOLZMANN MASCHINEN GmbH
WARNING
Component
Guideways
Change gears
Turning spindle
Adapter
Lead screw
Tailstock
Top slide
Cross slide
Lathe slide
Guideways
Head stock
Carbon brush
www.holzmann-maschinen.at
What to do?
oiling
lubricate lightly with grease
Check fastening
Grease or fill all grease nipples and
lubricators with machine oil.
Grease or fill all grease nipples and
lubricators with machine oil.
Adjust taper gib
Check V-belt and tighten if necessary
Check and replace if necessary
MAINTENANCE
56
ED300ECO
Tabla de contenido
