Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Do not work on the machine if it is tired, not concentrated or under the influence of
•
medication, alcohol or drugs!
Do not use the machine in areas where vapours from paints, solvents or flammable liquids
•
represent a potential danger (danger of fire or explosion!).
15.5
Electrical safety
•
Make sure that the machine is earthed.
Only use suitable extension cords.
•
Proper plugs and sockets reduce the risk of electric shock.
•
The machine may only be used if the power source is protected by a residual current
•
circuit breaker.
15.6
Special safety instructions for lathes
Clamp the workpiece firmly before turning on the lathe.
•
•
Clamp the lathe tool to the correct height and as short as possible.
Do not wear gloves when turning!
•
Keep sufficient distance from all rotating parts.
•
Switch off the lathe before measuring the workpiece.
•
Remove the clamping key from the chuck after each tool change.
•
•
Never remove any chips by hand! Use a chip hook, rubber wiper, hand brush or brush.
When using cooling lubricants, observe the manufacturer's instructions and use a skin
•
protection agent if necessary.
15.7
Hazard warnings
Despite intended use, certain residual risks remain when operating the machine.
Formation of a flow chip
•
-
This wraps around the forearm and causes severe cuts.
•
Throwing away workpieces or tools at high speed.
-
Always check workpieces for suitability and clamp them securely and firmly
-
Clamp and center longer workpieces via an additional counter bearing (e.g. tailstock)
-
For very long workpieces, use a steady rest
•
Risk of electric shock if incorrect electrical connections are used.
•
Risk of tripping due to supply lines on the floor.
-
Properly route supply lines and cables
-
Mark unavoidable tripping hazards yellow-black
Residual risks can be minimized if the "Safety instructions" and the "Intended use" as well as the
operating instructions are observed. Due to the design and construction of the machine,
hazardous situations may occur which are identified as follows in these operating instructions:
A safety instruction designed in this way indicates an imminently hazardous situation
which, if not avoided, will result in death or serious injury.
Such a safety instruction indicates a potentially hazardous situation which, if not
avoided, may result in serious injury or even death.
A safety instruction designed in this way indicates a potentially hazardous situation
which, if not avoided, may result in minor or moderate injury.
HOLZMANN MASCHINEN GmbH
DANGER
WARNING
CAUTION
www.holzmann-maschinen.at
SAFETY
40
ED300ECO
Tabla de contenido
