Use And Operation; Gas Connection - Becken S 5050 IX A Manual De Instrucciones

2. Use and Operation

2.1. Gas Connection

The cooker is provided with a label placed on the rear panel near the gas inlet,
showing the type of gas and pressure for which the appliance has been
originally adjusted.
Before connecting this appliance check if it is prepared for the type of gas and
pressure available in your home. If not, it is necessary to convert the appliance
to another gas as indicated in section 2.2.
All possible types of gas and pressures are shown on the data plate and in
table nr. 1.
The butane gas bottles are unable to function in places with low temperatures.
In this case it is advisable to replace the Butane for Propane gas (operation to
be done by a qualified installer). Never place a propane gas bottle inside a
building.
You may connect the appliance to a gas bottle fitted with its respective
regulator or to a gas network tap. Since this is a movable unit, the following
types of tubes can be used:
- Flexible rubber or elastomeric tube certified according an applicable
standard fixed to an adequate inlet gas connection and held tight by a
clamp on both ends.
- Flexible stainless steel tube certified according an applicable standard,
with threaded connections.
- Flexible rubber or elastomeric tube certified according an applicable
standard, with threaded connections.
Notes:
Ensure that the tube is not bent or twisted.
Ensure that the tube is not in contact with the rear panel.
The tube must be replaced before the expiring date.
You must check that the cable goes along the whole length
of the tube.
The clamps should be adequate for a good tight.
9