Kohler AQUALINE ST 2.36 C5 Manual De Utilización Y Mantenimiento página 25

8.2 Identification of the motor pump
The identification plate for the motor pump (example shown below) is affixed inside one of the side plates or on the base frame.
(C)
(D)
(B)
Serial numbers will be required when requesting troubleshooting advice or spare parts. For your records, please enter the motor
pump and engine serial numbers below.
Motor pump serial number:
....../.............. - ........................... - .........
8.3 Specifications
Model ST 2.36 C5
Engine type GX120_C5
330150405/330830
Maintenance kit
Recommended Unleaded petrol
fuel
Fuel tank capacity
Recommended oil 10W30
Oil sump capacity
Oil cut-out*
Spark plug type 330830005
Dimensions l x w 46,8 x 36,2 x 38 cm
x h
Weight (without
fuel)
Clean water or
Type of liquid water with low
levels of sediment
Granulometry of
the pumped liquid
Max. head height
Max. suction head
Suction diameter 50 mm
Discharge 50 mm
diameter
Max. L/min 600 L/min
flow
36 m
m 3 /h
rate
x: not available
*Oil cut-out: If there is no oil in the engine sump or if the oil pressure is low, the oil cut-out mechanism automatically stops the engine to prevent any
damage. If this occurs, check the engine oil level and top it up if necessary before looking for any other cause of the problem.
8.4 Recommended fuel quality
Using fuel which does not comply with the following specifications exposes the equipment to irreversible damage not covered under
warranty:
- Cleanliness and quality: ensure that the petrol used does not contain water and that it is fresh and clean (not out of date or
contaminated). For the
- Octane rating: minimum octane rating of 87 (R+M)/2 or minimum octane rating of 90 (RON = Research Octane Number)
- Blends: the use of unleaded petrol containing up to 10% ethyl alcohol is authorised (France: SP95-E10). It is not permitted
to use unleaded petrol containing less than 90% petrol, e.g. E15, E20 or E85. Blends of methyl tert-butyl ether (MTBE) and
unleaded petrol are approved (up to a maximum of 15% MTBE by volume).
However, it is strongly recommended that the same type of fuel is used throughout the complete service life of the unit. If the unit is
used infrequently (less than once a month), use new fuel with each use or add a stabilizing additive to the fuel tank.
(A) :
(A)
(B) :
(E)
(C) :
(F)
(D) :
(E) :
(G) (F) :
(G) :
ST 3.60 C5
GX160_C5
330150405/3308300
005 05
Unleaded petrol
2 L 3,1 L
10W30
0,6 L 0,6 L
O O
330830005
50,5 x 41,4 x 44,8
cm
23 kg
29 kg
Raw sewage
8 mm
8 mm
29 m 26 m
8 m 8 m
76 mm
76 mm
900 L/min
3 /h
54 m 3 /h
Model
CE/EAC marking
Maximum flow rate at zero head height
Suction and discharge diameters
Maximum head height
Weight of the motor pump
Serial number
Engine manufacturer:(e.g.
Kohler)
........................................
TR 2.36 C5
GX120_C5
330150405/330830
005
Unleaded petrol
2 L
10W30
0,6 L
O
330830005
46,8 x 36,2 x 39,8
cm
23 kg
Raw sewage
8 mm
29 m
8 m
50 mm
50 mm
600 L/min
36 m 3 /h
21/155
Engine serial number: (e.g Kohler (SERIAL
NO. 4001200908))
......................................................
TR 3.60 C5
GX160_C5
330150405/33083000 330150448/330830
5
Unleaded petrol Unleaded petrol
3,1 L
10W30
1,1 L
O
330830005
50,5 x 39,8 x 46,5 cm 69 x 48,5 x 53,2 cm
29 kg
Water with high
High pressure
levels of sediment
8 mm
26 m
8 m
76 mm
76 mm
900 L/min
54 m 3 /h
XT 3.78 C5
GX240_C5
005
5,3 L
10W30
0,6 L
O
330830005
58 kg
27 mm
27 m
8 m
76 mm
76 mm
1340 L/min
80,4 m 3 /h