Control Module - Wolf DD30 Manual Del Usuario

INSTALLATION
Installation

CONTROL MODULE

Use the template provided on page 11 to mark holes for
1
mounting screws. Drill one 1
3
two / " holes for the mounting screws.
(10)
8
CAUTION
Verify the scale of the template if not using the installa-
tion guide shipped with the downdraft.
Check countertop thickness to make sure threaded
2
studs are long enough to allow thumbnuts to fully
engage. Thicker countertops may require the countertop
be countersunk from below.
Place the control module on the countertop then secure
3
using the two nuts provided. Once secure, install the
ground wire and nut.
Use provided cable or cable designated by the National
4
Electric Code, NFPA/ANSI 70 or local codes. Connect
one end of the control cable to back side of control
module and other to electrical connection on front of
downdraft assembly. Ensure all connections are tight.
WARNING
Do not connect to telecommunication network.
GROUND
RJ45
CONNECTOR
Downdraft connection.
|
10 Wolf Customer Care 800.222.7820
All manuals and user guides at all-guides.com
9 / " in the center and
(40)
16
CONTROL MODULE
RJ45
CONNECTOR
NUT
GROUND
COUNTERTOP
Control module connection.
TOP COVER
Insert the downdraft plug into a grounded 3-prong recep-
tacle, then check operation. Once operation is verified, raise
the chimney and install the top trim using the three nuts
provided. Verify the top trim is properly aligned with the side
covers. Refer to the illustration below.
FILTERS
Remove stickers and shipping brackets and install filters.
Refer to the illustration below.
TOP COVER
Top cover installation. Filter installation.