Environmental Protection - Worx WU 100 Manual Del Usuario

OPERATING INSTRUCTIONS
1. ON/OFF SWITCH
Depress to start and release to stop your tool.
2. SWITCH LOCK-ON BUTTON
Depress on/off switch (2) then lock on button
(3) (See A), release on/off switch first and lock-
on button second.Your switch is now locked
on for continuous use.To switch off your tool
just depress and release the on/off switch.
3. FORWARD AND REVERSE ROTATION
CONTROL
For drilling and driving screws, use forward
rotation marked by an arrow "
moved to the left). Only use reverse rotation
marked by an arrow "
the right) to remove screws or bound drill bits.
Never change the direction of rotation when
the tool is rotating, wait until it has stopped
(See B).
4. VARIABLE SPEED CONTROL
Depress on/off switch to increase or decrease
the speed according to the material and
accessory to be used (also possible during no
load operation). Higher speed will produce
a higher torque while a lower speed will
produce a lower torque .
5. CHUCK ADJUSTMENT
To open the chuck jaws, hold chuck's rear
section rotate the front section of the chuck.
Ensure that the drill/driver bit is in the center
of the chuck jaws. Finally, firmly rotate the two
separate chuck sections in opposite directions
until the bit is secured in the chuck.You drill bit
is now locked in the chuck.
6. VERTICAL/HORIZONTAL BUBBLELEVEL
Your drill is equipped with a bubble level
that assists you in drilling level holes. For
horizontal drilling, tilt the drill up or down as
required so that the bubble floats in the centre
of the circle drawn on the plastic. For vertical
drilling, align the drill so that the bubble floats
in the centre of the bull's-eye. For greater
accuracy, place a level on your work piece
and position it so that it is in the vertical level.
(Any bubble level can only indicate level to the
earth's surface).
Note: The level is filled with mineral oil
that may cause minor skin irritation when
contacted If the level breaks and this fluid gets
on your skin, rinse thoroughly with water. If
Drill
13L-WU100-M-060824-FÓïCE´¦ÐÞ¸Ä.indd 7
All manuals and user guides at all-guides.com
any liquid gets in your eyes, rinse thoroughly
with wafer and call a physician immediately.
the front part of the chuck and turning the tool
on. Damage to the chuck and personal injury
may result.
WORKING HINTS FOR YOUR
DRILL
If your power tool becomes too hot set the
speed to maximum and run no load for 2-3
minutes to cool the motor.
" (lever is
When drilling in metal, only use HSS drill bits
in good condition.
"(lever is moved to
Always use a magnetic bit holder when using
short screwdriver bits.
Where possible use a pilot hole before drilling
a large diameter hole in the metal material.
MAINTENANCE
Your power tool requires no additional
lubrication or maintenance.There are no
user serviceable parts in your power tool.
Never use water or chemical cleaners to
clean your power tool. Wipe clean with a dry
cloth. Always store your power tool in a dry
place. Keep the motor ventilation slots clean.
Keep all working controls free of dust. If you
see some sparks flashing in the ventilation
slots, this is normal and will not damage your
power tool.
ENVIRONMENTAL
PROTECTION
Check with your local authorities or retailer for
recycling advice.
Warning: Do not attempt to tighten drill
bits (or any other accessory) by gripping
Waste electrical products should not
be disposed of with household waste.
Please recycle where facilities exist.
07
ENG
2007-3-5 15:42:56