SAME DEUTZ-FAHR iMonitor 2.0 Manual Del Conductor página 29

OPERATOR'S MANUAL
1.4 - WORK PARAMETERS SETTING
The work parameters can be expressed in numerical or percentage terms and then can be set by means of the touch screen or using
the MMI.
1.4.1 - Parameter setting with the touch screen
Parameter setting with the numerical keypad
To set the parameter value proceed as follows:
1. Select the parameter to be programmed by means of a short touch. This
action will display a numerical keypad that can be used to enter the re-
quired value.
Numerical keypad
1.1. Set value display fi eld
1.2. Parameter fi ne adjustment
1.3. Delete last number entered
1.4. Insert minus sign in front of value
1.5. Cancel entered value
1.6. Confi rm entered value
IMPORTANT
When an off-range value is entered in the monitor an error mes-
sage is displayed.
Clear the error message with button 1.
Adjustment with +/- buttons
To set the parameter value proceed as follows:
1. Select the parameter to be programmed by pressing the value display bar
(1) for around three seconds. This action displays the + and - buttons at the
ends of the bar.
2. Adjust the parameter precisely using the + and - buttons (2-3).
The parameters can be adjusted rapidly using the cursor on the bar (4).
Fig. 8
Fig. 9
Fig. 10
1-5