Adjustment - durher Ordesa M Manual De Instrucciones

5. Adjustment

Cutting blades of a diameter of less than 300
mm. or of more than 350 mm. with an inter-
nal diameter different from 25.4 mm. should
not be installed.
Blades different from those specified for this
machine should not be used:
- Continuous band diamond blades.
- Narrow grouting diamond blades.
- Wide grouting diamond blades.
In the event of noticing any defect in the machi-
ne elements, please put in out of service and
contact the distributor or manufacturer.
Head:
– The machine head can be fixed at 90º
and 45º, by means of the "1" bolt. (See
Graphic 5.1.).
Graphic 5.1. Adjustment of blade degrees
– Bolts "2" and "3" act as ends for 45º and
90º and should not be modified (See
Graphic 5.1.).
– The blade height can be adjusted by means
of the "4" handle (See Graphic 5.2.).
– In the Ordesa model the head can be pla-
ced at two different heights with the "5"
and "6" bolts and the holes: top for ø300
blade, and bottom for ø350 blade", (See
Graphic 5.1. and Graphic 5.2.).
– In the Teide model the height of the head
can be adjusted with the "7" and "8"
slots, using the spindle "9" to rise or
lower, fixing it with the handles "10" y
"11", at the lower part of the slots for
ø300 blade, rising it twenty five mm. for a
ø350 blade and in the top part of the
slots to cut in two stages up to 200 mm.
with 350 mm. blade (See Graphic 5.3.).
Graphic 5.2. Adjustmentof blade height
Graphic 5.3. Adjustment of TEIDE head height
42