Fittings And Accessories; Body; Sliding Lift-Up Partition; Securing The Loads - LAMBERET SR2 Manuel De Mantenimiento Y Uso

C. FITTINGS AND ACCESSORIES
1. The Body

1.1. Sliding Lift-up Partition

In the lifted-up position, the partition must be put away properly locked at the front
of the vehicle.
In the vertical position it must be properly locked to the floor and must be placed
between the two limits (marked in red inside the body so as to allow for the
stresses caused by the refrigerating power of the unit and its evaporators.
1.2. Securing the Load
A PARTITION MUST UNDER NO CIRCUMSTANCES BE USED TO RETAIN A
LOAD.
a) Half-grid
The maximum admissible horizontal load on a half-grid is 250 kg.
b) Securing Rails
The securing rails must be used
such that the maximum load
parallel to the rail does not exceed
250 kg.
The securing rails must not be
used to support an intermediate
level unless specially designed to
do so and with the manufacturer's
prior written approval.
c) Horizontal Bar
There are two types of horizontal bar:
¶ Square section: withstands a force equivalent to a weight of 700 kg.
¶ ∑ Circular section: withstands a force equivalent to a weight of 400 kg.

1.3. Duplex System

Never park under a beam that is not locked or holding a load and make sure after
each operation that it is properly locked into the vertical rails. The admissible
uniformly distributed effective load is shown on the front of each pulley.
22
SR/Version 1 September 2004