Kärcher CNS 18-30 Battery Manual De Instrucciones página 37

Protective gloves
Wear suitable protective gloves with cut protection
equipment that comply with EN 381-7 and are CE
marked when working with the device.
Leg protection
Wear suitable leg protectors with all-around protection
that comply with EN 381-5 and are CE marked when
working with the device.
Safety shoes
Wear non-slip safety shoes that comply with EN 20345
and are marked with a chainsaw symbol working with
the device. This ensures that the safety shoes comply
with EN 381-3.
If you only use the chainsaw occasionally, the ground is
level and there is little danger of tripping or snagging in
bushes, you can use safety shoes with steel front caps
and protective leggings that comply with EN 381-9.
Description of the device
The maximum amount of equipment is described in
these operating instructions. Depending on the model
used, there are differences in the scope of delivery (see
packaging).
See graphics page for illustrations
Illustration A
Chain
1
Guide rail
2
Bucking spikes
3
Chain oil tank cap
4
Hand guard/chain brake lever
5
Handle, rear
6
Trigger
7
Trigger lockout button
8
Battery pack unlocking button
9
Bar cover
10
Handle, front
11
Ring for adjusting the chain tension
12
Chain tensioner knob
13
Chain catcher
14
Type plate
15
Chain oil
16
Bar scabbard
17
*Battery Pack Battery Power 18V
18
*Quick Charger Battery Power 18V
19
* optional
Rechargeable battery pack
The device can be operated with a 18 V Kärcher Bat-
tery Power battery pack.
Installation
Mounting the chain and guide rail
CAUTION
Sharp chain
Incision injuries
Wear protective gloves when working on the chain.
1. Release the chain tensioner knob and remove the
bar cover.
Illustration B
2. Fit the chain on the guide rail. Observe the direction
of rotation of the chain.
Illustration C
3. Place the chain around the sprocket and insert the
guide rail.
Illustration D
4. Fit the bar cover and tighten the chain tensioner
knob.
Illustration E
5. Adjust the chain tension (see Chapter Adjusting the
chain tension).
6. Install the bar scabbard.
Illustration F
Filling the chain oil tank
1. If necessary, clean the area around the filling hole of
sawdust and dirt.
2. Remove the chain oil tank cap.
Illustration G
3. Slowly fill the chain oil into the tank.
Illustration H
4. Wipe up any spilled chain oil with a cloth.
5. Close the chain oil tank cap.
Checking the chain tension
CAUTION
Sharp chain
Incision injuries
Wear protective gloves when working on the chain.
1. Remove the bar scabbard.
Illustration I
2. Carefully pull on the chain.
Illustration J
The distance between the guide rail and the chain
must be 3-4 mm.
3. If necessary, adjust the chain tension (see Chapter
Adjusting the chain tension).
Installing the battery pack
1. Push the battery pack into the mounting in the de-
vice until it audibly latches into place.
Illustration K
1. Examine the tree and branches for damage such as
rot.
In the case of damaged or rotten branches, seek the
advice of a professional arborist.
2. Remove the bar scabbard.
3. Hold the device firmly with both hands.
Switch on the device
1. Pull the hand guard/chain brake lever in the direc-
tion of the handle.
Illustration L
The chain brake is released.
2. Press the trigger lockout button.
Illustration M
3. Press the trigger.
The device starts up.
English
Initial startup
Operation
Basic operation
37