HURAKAN HKN A700TN Manual Del Usuario página 34

EN
3.2. The delivery of additional shelves is specified in the order.
4. UNPACKING, ASSEMBLING AND PREPARING THE PRODUCT FOR
4.1. The product should be carefully unpacked, taking the necessary precautions against
mechanical damage to the external front surface of the product.
4.2. From the inner chamber to get accessories and documentation. Read the appliance
certificate. Check the completeness.
4.3. Remove the product from the wooden pallet by loosening the bolts securing of the product
to the pallet.
4.4. The product may only be moved in an upright position with an anchorage that excludes
any possible impacts and movement within transport facilities.
4.5. After transporting or storing at below-freezing temperatures, the cabinet must be kept at
room temperature (at least 12 ° C) for 24 hours before connecting it to the mains.
4.6. The product should be installed no closer than 1 m from the heaters. It is forbidden use the
product:
● when exposed to direct sunlight;
● on a draft or on a way of air ventilating streams, including from conditioners;
● in conditions of hindered air inflow to the compressor-condenser unit.
4.7. Screw in the support and use it to install the product with an inclination toward the rear
wall of 0,5 - 1 °, which amounts to a displacement of 25-30 mm from the vertical.
4.8. The internal and external surfaces of the product are covered with a protective
technological film, which must be removed before use. Then wash the surface of the product
with detergent and wipe dry.
4.9. Install brackets for shelves and shelves.
5. CONNECTION OF THE PRODUCT TO ELECTRICITY MAINS. SAFETY
5.1. The mains supply voltage should be 220V, frequency 50 Hz. Deviation of voltage from
rated voltage is not more than +/- 10%, frequency, not more than +/- 0,4%.
Note: If in your region the voltage drops of the mains voltage exceed these, it is
recommended that the product be connected to the network through special protective
and stabilizing devices.
5.2. The product has a power cord with a grounding prong and a plug with a ground contact.
5.3. The product is connected to the mains power supply(see Fig.1) via a combined (thermal
and electromagnetic) circuit breaker with setpoint current
QF1 - Circuit Breaker
34
OPERATION
PRECAUTIONS
Fig. 1 Wiring diagram of the product to the mains
Product