Installation - HEIDENHAIN ND 1400 QUADRA-CHEK Instrucciones De Instalación

ND 1400 QUADRA-CHEK
Installation Instructions
Operating Instructions available at www.heidenhain.de

6. Installation

The safety of any system incorporating the use of this product is the
responsibility of the assembler or installer of the system.
Interfaces
Rear
Power switch
3
Replaceable fuse holder
4
Power connector
5
Probe connector for 5-pin touch
6
probe sensor
Earth (ground) terminal
7
see warning
Remote accessory interface RJ-45
8
for optional foot switch accessory
Not used
9
10 Not used
11 Not used
Notice
Do not engage, or disengage any connections while the unit is under power.
Damage to internal components may result.
Notice
It is necessary to connect the earth (ground) terminal on the rear of the product
to the star point of machine ground. Minimum cross section of the connecting
2
wire: 6 mm . Never use this equipment without proper grounding.
14
Rear (cont)
12 Encoder inputs, X, Y, Z axis for
linear encoders Q axis for rotary
encoder
13 RS-232-C interface for PC
connection. RS-232 cable must not
include crossovers.
14 Probe connector for
HEIDENHAIN 15-pin
universal touch probe sensor
15 Audio out for 3.5 mm
headphone /speaker jack,
monaural, 8 Ohm
16 USB type A interface for printer
or data storage
Power cord
L: Line voltage (brown)
N: Neutral (blue)
Protective conductor (ground)
terminal(green/yellow)
3-conductor (grounded)
Min. cable cross section: 0.75 mm
Max. cable length: 3 m
2