Correction Of Malfunctions - WAGNER PowerPainter 60 Instrucciones De Funcionamiento Originales

GB

Correction of Malfunctions

Problem Cause
•
The sprayer does The sprayer is not plugged in.
•
not start. The device is switched off.
•
The sprayer was turned off while still under
pressure.
•
No voltage is coming from the wall plug.
•
The extension cord is damaged or has too low
a capacity.
•
There is a problem with the motor.
•
The spray device The unit will not prime properly or has lost
runs but does not prime.
•
suck up any paint The paint bucket is empty or the suction tube
when the selector is not totally immersed in the paint.
•
switch is set to the The suction tube is clogged.
•
PRIME position. The suction tube is loose at the inlet valve.
•
The inlet valve is stuck.
•
The inlet valve is worn or damaged.
•
The PRIME/SPRAY valve is plugged
•
The sprayer draws The spray nozzle is worn.
•
up paint but the The inlet filter is clogged.
•
pressure drops The gun filter is plugged. when the gun is
•
triggered. The paint is too viscous or contaminated.
•
The inlet valve is worn or damaged.
•
The spray gun leaks Internal parts of the gun are worn or dirty.
•
The nozzle The nozzle was assembled incorrectly.
•
assembly leaks A seal is dirty.
•
The spray gun will The spray nozzle or the gun filter is plugged.
•
not spray. The spray tip is in the reverse position.
•
The paint pattern is The paint is too viscous or contaminated.
•
tailing. The spray nozzle or the gun filter is plugged.
•
The spray nozzle is worn.
•
The inlet filter is clogged.
•
The gun filter is plugged.
•
The inlet valve is worn or damaged.
26
PowerPainter 60
Remedy
Plug the sprayer in.
➞
Turn the ON/OFF switch to ON.
➞
Perform pressure relief procedure and set selector
➞
switch back to SPRAY
Properly test the power supply voltage.
➞
Replace the extension cord.
➞
Please contact Wagner Service
➞
Try to prime the unit again.
➞
Refill the bucket or immerse the suction tube in
➞
paint.
Clean the suction tube.
➞
Tighten it securely.
➞
Press the inlet valve pusher. If the problem is not
➞
solved, clean the inlet valve.
Replace
➞
Please contact Wagner Service
➞
Replace the spray nozzle with a new nozzle.
➞
Clean the inlet filter.
➞
Clean or replace the filter. Always keep extra filters on
➞
hand.
Thin or strain the paint.
➞
Replace
➞
Please contact Wagner Service
➞
Check the tip assembly and assemble properly
➞
Clean the seal.
➞
Clean the spray nozzle or gun filter.
➞
Put the nozzle in the forward position.
➞
Thin or strain the paint.
➞
Clean the spray nozzle or gun filter.
➞
Replace the spray nozzle with a new nozzle.
➞
Clean the inlet filter.
➞
Clean or replace the filter. Always keep extra filters on
➞
hand.
Replace
➞