W 550
Correction of Malfunctions
Problem
No coating material
emerges from the
nozzle
Coating material drips
from the nozzle
Atomisation too coarse
Spray jet pulsates
Coating material causes
"paint tears"
Too much fog of
coating material
(Overspray)
Paint in the ventilating
hose
Environmental protection
The appliance and accessories should be recycled in an environmentally
friendly way. Do not dispose of the appliance with household waste. Support
environmental protection by taking the appliance to a local collection point or
obtain information from a specialist retailer.
Important Note regarding Product Liability!
Due to an EC ordinance in effect since 01.01.1990, the manufacturer is liable for his product
only if all parts originate from or were approved by the manufacturer and the devices are
assembled and operated correctly. The use of other accessories and spare parts can partially
or completely invalidate the liability.
Cause
Nozzle clogged
Feed tube clogged
Material volume setting turned too far
to the left (-)
Feed tube loose
No pressure build-up in container
Nozzle loose
Nozzle worn
Nozzle seal worn
Coating material assembly at air cap,
nozzle or needle
Viscosity of coating material too high
Material volume too large
Material volume adjusting screw turned
too far to the right (+)
Nozzle contaminated
Air filter heavily soiled
Too little pressure build-up in container
Coating material in container running
out
Air filter heavily soiled
Too much coating material applied.
Distance to the object too large
Too much coating material applied
Diaphragm soiled
Diaphragm defective
Remedy
Clean
Clean
Turn to the right (+)
Insert
Tighten container
Tighten
Change
Change
Clean
Thin
Turn material volume adjusting
screw to the left (-)
Clean
Change
Tighten container
Refill
Change
Turn material volume adjusting
screw to the left (-)
Reduce distance
Turn material volume adjusting
screw to the left (-)
Clean the diaphragm
Replace the diaphragm
GB
29