Preparing A New Sprayer - Titan SPEEFLO PowrLiner 2850 Manual Del Propietário

Trigger Selector (Two-Gun units)
1. Set the trigger selector for proper spray gun operation. The
gun lever on the right handlebar triggers the gun or guns.
The selector on the trigger must be set for the first gun, both
guns, or the second gun .
ImPORTANT: Always turn the trigger lock on the spray gun to
the locked position before making any adjustments to the trigger
selector. Also, release the trigger cable from its block by lifting
the cable up and out of the block. There will be a brief triggering
of the gun while releasing the trigger cable.
a. First Gun — The first gun
position is with the selector
in the left position. Push the
lever toward the inside of the
frame until the pin engages
the left plate.
b. Both Guns — The dual gun
position is with the selector
in the center position. Push
the lever toward the center
position until the pin engages
both plates. The pin must
engage both plates.
c. Second Gun — The second
gun position is with the
selector in the right position.
Push the lever away from the
inside of the frame until the
pin engages the right plate.
English

Preparing a New Sprayer

If this unit is new, it is shipped with test fluid in the fluid section to
prevent corrosion during shipment and storage. This fluid must be
thoroughly cleaned out of the system with mineral spirits before you
begin spraying.
ImPORTANT: Always keep the trigger lock
on the spray gun in the locked position
while preparing the system.
1. Place the siphon tube into a container
of mineral spirits that has a flash point
of 60ºC (140ºF) or above.
2. Place the return hose into a metal
waste container.
3. Turn the pressure control knob fully
counterclockwise to its lowest pressure
setting.
4. Move the PRIME/SPRAY valve to the
PRIME position.
5. Move the engine ON/OFF switch to the
ON position.
6. Start the engine:
a. Open the fuel valve
lever.
b. Move the throttle lever
to its middle point.
c. Close the engine choke
lever.
d. Holding the frame
with one hand, pull the
starter rope rapidly and
firmly. Continue to hold
the rope as you let it
return. Pull and return
the rope until the engine starts.
7. Turn on the sprayer by moving
the pump ON/OFF switch to
the ON position.
8. Allow the sprayer to run for
15–30 seconds to flush the
test fluid out through the
return hose and into the waste
container.
9. Turn off the sprayer by moving
the pump ON/OFF switch to
the OFF position.
6
Trigger lock in
locked position.
PRIME
Throttle
Choke Lever
Lever
Engine
ON/OFF
Switch
Fuel Valve
Lever Starter Rope
Sprayer Pressure
ON/OFF Control
Switch Knob
© Titan Tool Inc. All rights reserved.