Tripp-Lite SmartOnline SU750XL Manual Del Usuario página 9

Sistemas ups realmente en línea de torre
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Basic Operation
"REPLACE BATT" LED: This red light will illuminate constantly and the UPS
alarm will beep every 2 seconds if your UPS microprocessor detects a
battery fault or if your UPS fails the automatic self-test (after you turn your
UPS ON) and the UPS battery is less than fully charged. Let the UPS
system charge for at least 12 hours and perform a self test using the "ON/
TEST Button". If the light continues to stay on, contact Tripp Lite for
service.
Rear Panel
Accessory Slot: Remove the small cover panel from this slot to use
optional accessories to remotely monitor and control your UPS. Visit www.
tripplite.com for compatible SNMP , network management and connectivity
products.
External Battery Pack Connector (Varies by Model): Use to connect
optional Tripp Lite Battery Packs for additional runtime. Visit www.tripplite.
com/products/battery-finder/ to find a compatible battery pack. Refer to
your external battery pack Owner's Manual for complete connection
information and safety warnings.
Fan: The fan cools UPS internal components. It is always on when line
power is present.
Input Circuit Breaker Switch: This resettable breaker prevents high input
current from damaging the UPS or the attached load. If this breaker trips,
make sure your UPS is connected to AC power of the proper voltage before
resetting the circuit breaker by pushing the breaker switch in.
Input Cord: This permanently attached power cord connects your UPS to a
power outlet.
AC Receptacles (varies by model): These 15-, 20- or 30-amp
receptacles provide your connected equipment with pure sine-wave AC
output from the AC line during normal operation and by battery power
during blackouts and severe brownouts. Power provided to these outlets is
filtered to protect connected equipment against damaging surges and line
noise. The receptacles are divided into numbered load banks, as labelled
on the unit. Using PowerAlert software and cabling, load banks one and
NEMA 5-15R
two may be individually turned off and on from a remote location, allowing
users to reset or reboot connected equipment.
NEMA 5-15/20R
Other outlet types not shown
9
17-05-031-932470.indb 9
5/23/2017 1:52:11 PM
Tabla de contenido
loading

Tabla de contenido