Filter Installation And Cleaning; Dry Pick Up Operation - Shop-Vac SE Serie Manual Del Usuario

FILTER
INSTALLATION
AND CLEANING
DRY PICK UP
OPERATION
NOTE: Never use the vacuum for dry pick up without a
dry use filter installed on the lid cage. Using the vacuum
without a filter will cause dust to discharge from blower
port and cause damage to motor.
INSTALLING AND CLEANING THE CARTRIDGE
FILTER:
WARNING!
ALWAYS DISCONNECT THE
PLUG FROM THE WALL OUTLET
BEFORE REMOVING THE TANK
COVER.
NOTE: If foam sleeve (not standard with all models)
is installed on lid cage, remove before installing the
cartridge filter.
25. The cartridge filter can be used for dry pick up and
small quantities of wet pick up. Installation is the same
for both. When picking up large quantities of water we
recommend using a foam sleeve (not standard with
all models) instead of the cartridge filter. When picking
up fine dust or powders a high efficiency filter bag (not
standard with all models) must be used with the
cartridge filter.
NOTE: If cartridge filter has been used for wet pick
up, it must be cleaned and dried before using it for dry
pick up.
FIGURE 24
FIGURE 25
26. With the tank cover in an
upside down position, slide
the cartridge filter down over
the lid cage, pushing until the
filter seals against the cover.
FIGURE 24.
27. Place filter retainer into the
top of the cartridge filter.
FIGURE 25.
FIGURE 26
FIGURE 27
FIGURE 28
FIGURE 29
FIGURE 30
33. Check the filter for tears or small holes. If none are
found, reinstall the filter. To prevent damage to your
vacuum, do not use a filter with a hole or a tear.
WARNING!
KEEP FILTERS CLEAN. EFFICIENCY OF THE VACUUM
IS LARGELY DEPENDENT ON THE FILTER. A CLOGGED
FILTER CAN CAUSE OVERHEATING AND POSSIBLY
DAMAGE THE CLEANER. CHECK THE FILTER
PERIODICALLY AND REPLACE AS REQUIRED.
INSTALLING THE DISPOSABLE FILTER BAG:
WARNING!
ALWAYS DISCONNECT THE
PLUG FROM THE WALL
OUTLET BEFORE REMOVING
THE TANK COVER.
28. Hold the tank cover with
one hand, turn the handle on
the filter retainer clockwise to
tighten, locking the filter into
place. FIGURE 26.
29. To remove the filter for
cleaning, again hold the
tank cover and turn the filter
retainer counter-clockwise to
loosen and remove.
FIGURE 27.
30. Slide the cartridge filter off
the lid cage. FIGURE 28.
31. To clean cartridge filter
shake or brush off excess dirt.
FIGURE 29.
32. Or rinse (from the inside of
the filter) with water.
FIGURE 30. Dry completely
(approximately 24 hours).
PAGE 7