Filter Installation And Cleaning; Dry Pick Up Operation - Shop-Vac SMK Serie El Manual Del Propietario

FIGURE 6
6. Plug the cord into the wall outlet. Your cleaner is ready for use. I = ON, O = OFF
KICK STAND INSTRUCTIONS
7. Remove wands from wand clips, pull lid latches in an outward motion and remove tank cover. Place back of lid into cutout on back
of tank, below cord. FIGURE 7. Lift kick stand from rim on inside of tank. FIGURE 8. and snap into notch in front of cartridge filter.
FIGURE 9. To replace tank cover return kick stand to notch in tank, lift cover and align with tank rim. Apply pressure with thumb to
each latch until it snaps tightly into place. Make certain all lid latches are clamped securely.
FIGURE 7

FILTER INSTALLATION AND CLEANING

DRY PICK UP OPERATION

WARNING:
BEFORE REMOVING THE TANK COVER.
8. The cartridge filter can be used for dry pick up and small quantities of wet pick up. Installation is the same for both. When picking
up large quantities of water we recommend using a foam sleeve (not standard with all models) instead of the cartridge
filter. When picking up fine dust or powders a high efficiency filter bag must be used with the cartridge filter.
9. With the tank cover in an upside down position, slide the cartridge filter down over the filter cage, pushing until the filter seals
against the cover. FIGURE 10.
10. Place filter retainer into the top of the cartridge filter. FIGURE 11.
11. Hold the tank cover with one hand, turn the handle on the filter retainer clockwise to tighten, locking the filter into place.
FIGURE 12.
PAGE 6
NOTE: MANY MORE USEFUL TOOLS ARE AVAILABLE AT YOUR
LOCAL LOWE'S STORE, LOWES.COM OR SHOP-VAC.COM.
FIGURE 8
NOTE: NEVER USE THE VACUUM FOR DRY PICK UP WITHOUT A DRY USE
FILTER INSTALLED ON THE FILTER CAGE. USING THE VACUUM WITHOUT A
FILTER WILL CAUSE DUST TO DISCHARGE FROM BLOWER PORT AND CAUSE
DAMAGE TO MOTOR.
ALWAYS DISCONNECT THE
NOTE: IF FOAM SLEEVE (NOT STANDARD WITH ALL MODELS) IS INSTALLED
ON FILTER CAGE, REMOVE BEFORE INSTALLING THE CARTRIDGE FILTER.
NOTE: IF CARTRIDGE FILTER HAS BEEN USED FOR WET PICK UP, IT MUST BE
CLEANED AND DRIED BEFORE USING IT FOR DRY PICK UP.
FIGURE 9
PLUG FROM THE WALL OUTLET