Filter Installation And Cleaning; Dry Pick Up Operation - Shop-Vac ESLSQ550 Manual De Instrucciones

FIGURE 9
FIGURE 10
FIGURE 11
15. Repeat steps 11 through 14 for other wheel
assembly.
16. Return tank to upright position.
ACCESSORY BASKET
ASSEMBLY
(Not standard with all models)
FIGURE 12
FIGURE 13
19. Press down until basket is secured into place.
PAGE 6
12. Insert wheel plug through
wheel and axle housing
turning wheel plug until it
seats flush with outside of
wheel. FIGURE 9.
13. Insert screw provided
through back of axle housing.
FIGURE 10.
14. Slide axle housing into
dovetail slot at rear of tank:
axle housing is tapered and
should slide into dovetail
slot without excessive force.
FIGURE 11. Tighten screw.
17. With rear of tank facing
you, take accessory basket and
position with tabs facing rear of
tank. FIGURE 12.
18. Insert tabs of accessory
basket into slots on rear of
tank. FIGURE 13.
TOOL HOLDER
ASSEMBLY
(Not standard with all models)
20. Replace tank cover and apply pressure with thumbs
to each latch until it snaps tightly in place. Make sure
both lid latches are clamped securely.
FIGURE 14
FIGURE 15
23. Press down until tabs snap into place.
NOTE: TOOL HOLDER NOT COMPATIBLE WITH
ACCESSORY BASKET.
FILTER
INSTALLATION
AND CLEANING
DRY PICK UP
OPERATION
WARNING!
ALWAYS DISCONNECT THE
PLUG FROM THE WALL OUTLET
BEFORE REMOVING THE TANK
COVER.
WARNING!
KEEP FILTERS CLEAN. EFFICIENCY OF THE
VACUUM IS LARGELY DEPENDENT ON THE
FILTER. A CLOGGED FILTER CAN CAUSE
OVERHEATING AND POSSIBLY DAMAGE THE
CLEANER. CHECK THE FILTER PERIODICALLY
AND REPLACE AS REQUIRED.
21. With rear of unit facing
you, take tool holder and
position it with the tabs
facing rear tank cover.
FIGURE 14.
22. Press tabs of tool holder
into the slots on mounting
lugs on rear of tank cover.
FIGURE 15.