Maintenance; Replacing The Battery - Promax PRODIG-1+ Manual De Instrucciones

USER'S MANUAL PRODIG-1+.

5. MAINTENANCE

5.1 Replacing the Battery

The battery (CB-075) should be replaced when you notice that its capacity, when
fully-charged, has fallen below 60% of its nominal value.
Replace the old battery by another CB-075 battery. The battery can be bought in
your habitual PROMAX supplier. Explosion or fire hazard can occur if other battery type
is used.
The battery used can present fire or chemical burn hazard if it is severely mistreat.
Do not disassembly or cremate or heat the battery above 100ªC under no
circumstances.
To replace the battery, please follow the process below:
1. Switch off the instrument.
2. Remove the battery-compartment lid on the rear panel, by extracting the 2
retaining screws.
3. Disconnect the battery cable and the NTC sensor cable from the instrument.
4. Replace the battery with a new one.
5. Connect the battery to connector J6 next to the battery receptacle, as well as
the NTC sensor cable to connector J8 (see figure 16). Each connector has only
one position.
6. Place and secure the battery compartment lid using the 2 screws.
All the components of the Ni-MH battery included in the CB-075 ensemble are
recyclable. Return as soon as possible the used battery to PROMAX ELECTRONICA
S.A. or to an authorised recycling centre of this type of batteries. If any doubt, consult
directly PROMAX ELECTRONICA,S.A.
Keep them out of the reach of the child.
If in any doubt, please contact our Customer Service Centre before undertaking any
operation.
05/2003
CAUTION
CAUTION
Page 21