Ryobi ETS-1525SC Manual De Operacion Del Propietario página 23

OPERATION EXTENSION TABLE (FIG. 23)
Move extension table along the rod direction
to desired position by pushing and pulling
extension table.
INSTALL SLIDING TABLE (FIG. 24,25,26&27)
Align the two sliding table rods(a) with the
holes(b) in the two wings of main table.
(FIG.24)
Push sliding table(3) to a certain position and
mount two screws one in the front side and the
other in the back side to the holes at the end of
both rods. (Fig.25&26)
OPERATION SLIDING TABLE (FIG. 27)
Move sliding table(3) along the rod direction to
desired position by pushing & pulling the
sliding table.
Push the knobs(a) down to fasten sliding table
to main table.
Tighten the sliding table lock knobs(b) to stop
the two sliding bearings from moving.
Set the mitre gauge(9) to the desired angle
and tighten the mitre gauge lock knob (10).
Push the knobs(a) down to fasten extension
table to main table.
Slide mitre gauge(9) into groove in the
sliding table(3) and tighten the mitre gauge
lock knob(10). (Fig.27)
Make sure the wood is clear of the blade
before turning on the saw.
Allow the blade build up to full speed before
moving the workpiece into the blade.
Feed the workpiece into the blade until the
cut has been completed.
16