Troubleshooting - EGO HT5100E Manual De Usuario

TROUBLESHOOTING

PROBLEM CAUSE
◾
The battery pack is not attached to
the hedge trimmer.
◾
No electrical contact between the
trimmer and battery
◾
The battery pack is depleted.
◾
The battery pack is too hot.
Hedge trimmer
doesn't work.
◾
The hedge trimmer is too hot.
◾
The two switch levers are not
depressed simultaneously.
◾
The blade is jammed.
◾
Dry or corroded blades.
◾
Blades or blade support is bent.
Excessive
vibration or
noise.
◾
Bent or damaged teeth.
◾
Loose blade bolts.
WARRANTY
EGO WARRANTY POLICY
Please visit the website egopowerplus.com for full terms and conditions of the EGO Warranty policy.
56 VOLT LITHIUM-ION CORDLESS HEDGE TRIMMER — HT5100E
SOLUTION
◾
Attach the battery pack to the hedge trimmer.
◾
Remove battery, check contacts and reinstall the
battery pack.
◾
Charge the battery pack.
◾
Remove the battery pack from the tool and allow it
to cool until the temperature drops below 67°C.
◾
Release both switch levers; allow the trimmer to
cool until the temperature drops below 77°C.
◾
Depress the switch levers on the front and rear
handle simultaneously.
◾
Remove the battery pack from the tool, remove the
obstruction carefully, then reinsert the battery and
restart the tool.
◾
Lubricate the blades, following the section
"LUBRICATING THE BLADE" in this manual.
◾
Replace with a new blade or support. Contact EGO
service center for blade or support replacement
service.
◾
Replace with a new blade. Contact EGO service
center for blade replacement service.
◾
Tighten the blade bolts. Using a wrench, turn the
bolt clockwise to tighten.
EN
11