Ryobi RY906500S Manual Del Operador página 11

Ocultar thumbs Ver también para RY906500S:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

SYMBOLS
located in an open, outdoor area. Always point exhaust away from occupied structures. Never run the generator in enclosed
areas (e.g. not in a house or garage).
DO NOT tamper with, adjust, or modify the carbon monoxide (CO) sensor module on your generator.
FUEL WARNING
No smoking when filling with gasoline.
Do not overfill. Full level is 1 in. below
the top of the fuel neck. Stop the en-
gine for five minutes before refueling to
avoid the heat from the muffler igniting
fuel vapors.
CHECK LUBRICANT
ENGINE LUBRICANT WARNING
You must add lubricant before first
operating the generator. Always check
940708019-03
the lubricant level before each opera-
tion. The lubricant level should always
register between the hatched areas on
the dipstick. The unit is equipped with
a sensor which will automatically shut
off the engine if the lubricant level falls
below a safe limit.
WARNING
GROUNDING WARNING
HOT SURFACE AND EXHAUST
This generator does not include a ground rod or copper wire. Call
a qualified electrician for local grounding requirements.
AVERTISSEMENT
SURFACE ET D'ECHAPPEMENT CHAUD
HOT SURFACE WARNING
ADVERTENCIA
Do not touch the muffler or aluminum cylinder of the engine. They
SUPERFICIE Y DE ESCAPE ESTEN CALIENTE
are very HOT and will cause severe burns. Don't put body parts or
940680027-05
any flammable or combustible materials
in the direct path of the exhaust.
CLEARANCE WARNING
While operating and storing, keep at
least 3 feet of clearance on all sides of
this product, including overhead. Allow a
minimum of 30 minutes of "cool down"
time before storage. Heat created by
muffler and exhaust gases could be hot enough to cause serious
burns and/or ignite combustible objects.
SPARK ARRESTOR
Operation of this equipment may create sparks that can start fires
around dry vegetation. A spark arrestor may be required. The
operator should contact local fire agencies for laws or regulations
relating to fire prevention requirements.
FUEL CAP WARNING
Never remove fuel cap when unit is running. Shut
off engine and allow the unit to cool at least five
minutes. Remove cap slowly to release any pres-
sure built up in the fuel system and to avoid the
heat from the muffler igniting fuel vapors.
Page 7 — English
Tabla de contenido
loading

Este manual también es adecuado para:

Ry906500vnm

Tabla de contenido