Troubleshooting; Safety Notices; Cause And Action - Caso GERMANY VC12 Manual Del Usaurio

16 Troubleshooting

This chapter provides you with important notices with regard to operating
the device. Observe the following notices to avoid dangers and damages:
16.1

Safety notices

► Only qualified electricians, who have been trained by the manufacturer,
may carry out any repairs on electrical equipment.
► Improperly performed repairs can cause considerable dangers for the
user and damages to the device.
16.2

Cause and Action

In the event of a fault, an error code will appear in the display; it describes
the cause of the fault.
Error
Vacuum unit is not
functioning
The first weld on the cut
off piece of the roll is not
being carried out.
A complete vacuum is not
being created in the bag.
The bag is not being
welded correctly
The bag does not hold the
vacuum after it has been
welded shut
caso Vakuumierer VC12
Attention
Possible cause
Power plug is not plugged
in
Defective power cable or
plug
Defective electrical socket
Roll is not positioned
correctly
The open end of the bag is
not completely inside the
vacuum chamber
The bag is defective
There is dirt on the
welding and the normal
seals
The welding bar is
overheating so that the
bag melts
The bag is defective
Rectification
Plug in mains plug!
Send device to Customer Service
Select another electrical socket
Follow the steps in the chapter
"Vacuum packaging in a bag
originating on the roll"
Position the bag correctly
Select another bag
Clean the seals and retry correctly
once they are dry
Open the cover on the unit and let
it cool down for a few minutes
Select another bag; wrap paper
serviettes around any sharp edges
on the content
49