Garland MULE 1162 NRQG Manual De Instrucciones página 49

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 1
cannot guarantee their safety. If you are working on
slopes slow down your work pace and ensure you
have good stability.
Be alert when you back-up or pull the machine
towards you.
Do not solely rely on the security features of this
machine.
It is necessary to pay attention to the possible
loosening or overheating of the parts of the machine. If
you detect any anomaly immediately stop the machine
and check it carefully. In case of mechanical failure
take the machine to the technical service for repair.
You should not continue working if you notice that the
operation is not correct.
Remember to always use the machine with clean
hands and without any fuel or oil remains.
Clean the work area and remove all obstacles that may
cause accidents. Check the work area when going to
work and remove all items that could become entangled
in the cutting tool. Also remove all the objects that the
cutting tool can violently eject in the operation.
Do not allow anyone to enter the work perimeter. This
work perimeter must be 15 meters and is a danger
zone.
Never leave this machine unattended.
Be careful not to touch the hot parts of the
machine while the engine is running or
after use, such as exhaust, spark plug or high voltage
cables.
Do not use other accessories this machine except
those recommended by our company since its use
could cause severe damage to the user, people close
to the machine and the machine itself.
Always follow the safety rules given in this manual.
7.1. HOLDING AND GUIDING THE MACHINE
While working always place yourself behind the
machine and hold it firmly with both hands on the
handles.
Warning! Do not use this rotary tiller with one
hand.
the ground is frozen. Always firmly hold the machine
with both hands.
This machine clutch is deactivated (disengaged)
by default, to activate the clutch and for the engine
power to transmit to milling cutters, the clutch lever
must be tightened.
Warning! The clutch lever has a safety lock to
moving the finger lock down and, without releasing
the lock,
tighten the clutch lever.
7.1.1. SHIFTING GEARS
This machine has a gearbox with two speeds: forward
and backward speed. To change gear, release the
clutch lever (to disengage the milling cutters of the
engine) and choose the desired speed by moving the
49/184
Warning! This rotary tiller could
bounce upwards or jump forwards
unexpectedly. If the teeth hit
something hard that is buried in the
ground such as large stones, roots
or trunks, if the soil is too hard or if
prevent accidentally engaging
the machine.
To activate the clutch you must
first remove the safety lock by
English
Tabla de contenido
loading

Tabla de contenido