Free-Hand Cutting - RIDGID RS-570 Manual De Instrucciones

Lift Handle
Figure 14 – Adjusting Clamp Handle
5. Plug the saw in.
6. Align and insert the saw mount hole over
the saw mounting pin on the support de-
vice. Confirm that the saw blade aligns with
the desired cut location.
7. Grasp the saw rear handle.
8. Turn saw ON and allow the blade to come
to full speed.
9. Lift the saw to bring the blade into contact
with the pipe. Apply even force to the saw
to cut the pipe. Figures 15A-C.
Figure 15A– Cutting the Pipe
999-995-148.09_REV. B
RS-570 Reciprocating Saw
Figure 15B– Cutting the Pipe
Figure 15C– Cutting the Pipe
10. Continue applying force until the pipe is cut
through.
11. Turn the saw OFF and allow the blade to
come to a stop. Unplug the saw.

Free-Hand Cutting

1. Plug the saw in.
2. Firmly grasp the saw handles.
3. For straight or contour cutting from the ma-
terial edge, with the saw shoe firmly against
the material, align the blade with cutting
mark on work piece.
4. Turn saw ON and allow the blade to come
to full speed.
5. Guide the tool along cutting mark to cut as
desired. Always hold the shoe firmly against
the workpiece to avoid excessive vibration
(Figure 16).
6. Turn the saw OFF and allow the blade to
come to a stop. Unplug the saw.
11