Teac A-R630 Manual Del Usuario página 7

A
Remote Sensor
When operating the remote control unit, point it towards the
REMOTE SENSOR.
B
POWER
Press this switch to turn the unit standby or off.
C
STANDBY/ON
When the power switch of the main unit is depressed, use this
button to turn the unit on or standby.
The standby indicator lights when the unit is in the standby
mode. When the unit is turned on, it goes off.
D
INPUT SELECTOR
Use this knob (or buttons of the remote control unit) to select a
source.
One of the indicaotrs lights to show the selected source.
E
TAPE 2 MONITOR
When a cassette tape deck is connected to the TAPE 2 jacks, use
this button to turn on or off the tape monitor function.
The indicator lights when the tape monitor function is on.
F
MUTING
Use this button to mute the sound.
This indicator blinks during the muting.
G
VOLUME
Turn this knob (or press the VOLUME buttons of the remote
control unit) to adjust the volume.
H
MIC Jack and MIC LEVEL knob
With the microphone plugged into this jack, the sound picked
up from the microphone will be heard together with the source
sound selected by the INPUT SELECTOR.
Turn the MIC LEVEL knob to adjust the input level of the
microphone.
I
LOUDNESS
Use this button to compensate for the loss of bass at low
volumes.
J
BALANCE
Use this knob to adjust the balance of the speakers.
Normally, set the knob to the center position.
K
SOURCE DIRECT
Press this button to turn on or off the source direct function.
When the source direct function is set to on, the button lights
and you can listen to the sound without tone effects.
L
TREBLE
Use this knob to adjust the level of high frequency information.
M
BASS
Use this knob to adjust the level of low frequency information.
N
SPEAKERS buttons
Use these buttons to turn on or off the speakers.
on : Sound is output from the speakers.
off : No sound is output from the speakers.
O
PHONES jack
For private listening, insert the headphones plug into this jack,
and adjust the volume by turning the VOLUME knob.
Remote Control Unit
When operating the CD Player (CD-P650) or the tuner (T-R650/
T-R650DAB) using the remote control unit, select a source first
using INPUT SELECTOR buttons (boxed
control unit.
a
ON
When the POWER switch of the main unit is depressed, use this
button to turn the unit on.
b
STANDBY
When the POWER switch of the main unit is depressed, use this
button to turn the unit standby.
Other buttons are used for operation of TEAC's CD-P650,
T-R650 and T-R650DAB.
Note:
< To simplify explanations, instructions in this manual refer to
the names of the buttons and controls on the front panel only.
Associated controls on the remote control will also operate
similarly.
D
) on the remote
7