RIDGID R4513 Manual Del Operador página 16

ASSEMBLY
 Place the center brace on top of the inner leg assembly
(curve side up) with the stop pin under the pedal assembly
latch.
NOTE: The stop pins rest on top of inner leg assembly.
 Insert a carriage bolt through the top hole of the inner leg
assembly then slide a large spacer on the bolt. Repeat
for the other side.
 Slide the center brace onto the bolt and secure in place
using a lock nut. Repeat for the other side.
 With the curve handle turned downward, secure the upper
tubes to the leg stand using carriage bolts, spacers, and
lock nuts.
 Slide the flat washer (large), wheel, and flat washer (small)
onto the axle through the hole in the center of the wheel.
Secure in place using lock nut.
 Repeat with the second wheel.
 Before use, verify the release lever locks the leg stand
securely. If the leg stand will not lock, do not use; contact
an authorized service center for assistance.
CENTER
BRACE
STOP PIN
LARGE
SPACER
CARRIAGE
LOCK
NUT
INNER LEG
ASSEMBLY
CARRIAGE
BOLT
BOLT
LEG STAND
WHEEL
Fig. 9
LOCK
FLAT WASHER,
NUT
16 − English
UPPER
TUBE
LOCK
NUT
FLAT WASHER,
LARGE
SMALL
LARGE
SPACER
SMALL
SPACER
Fig. 10
Fig. 11