Transferring All Cycles From Computer To Simulator; Transferring One Cycle From Computer To Simulator - Alliance Laundry Systems SF135PV Manual De Instrucciones

Transferring All Cycles from Computer to
Simulator
All keypad commands will be entered with the
simulator keypad.
Use the following procedure to transfer all cycles
contained in the memory of the computer to the
simulator. (Transferring 39 cycles takes about
6 seconds.)
1. Connect the fiber optic cables between the
simulator and the computer. Verify that the
colored plugs on the ends of the optic cables
match the colors of the ports on the simulator and
on the washer-extractor's control module (gray to
gray, blue to blue).
2. Place both the simulator and the computer in the
Program Mode. The display on both will read
"CYC00".
3. Press key 0. The display will read "WRITE?".
4. Press key 0 again. The display will change to
"READ?".
5. Press the Enter key. The display will read "ALL".
6. Press the Enter key again. The simulator display
will flash "RECV" and "ALL" alternately. The
computer display will flash "SEND" and "ALL"
alternately.
When the two displays stop flashing, the transfer
is complete.
F232101
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Transferring One Cycle from Computer to
Simulator
All keypad commands will be entered with the
simulator keypad.
Use the following procedure to transfer one cycle
contained in the memory of the computer to the
simulator. (Transferring 1 cycle takes less than
1 second.)
1. Connect the fiber optic cables between the
simulator and the computer. Verify that the
colored plugs on the ends of the optic cables
match the colors of the ports on the simulator and
on the washer-extractor's control module (gray to
gray, blue to blue).
2. Place both the simulator and the computer in the
Program Mode. The display on both will read
"CYC00".
3. Press key 0. The display will read "WRITE?".
4. Press key 0 again. The display will change to
"READ?".
5. Press the Enter key. The display will read "ALL".
6. Press key 0. The display will read "CYC".
7. Press the Enter key. The display will read
"RCYC00".
Now press the 2-digit code for the desired cycle
number from the computer.
8. Press the Enter key. The display will read
"WCYCcc".
Now press the 2-digit code for the desired cycle
number under which the cycle should be saved in
the simulator.
9. Press the Enter key. The simulator display will
flash "RECV" and "CYC" alternately. The
computer display will flash "SEND" and "CYC"
alternately.
When the two displays stop flashing, the transfer
is complete.
Programming
59