Installing The Faucet - Glacier bay QK004 Guía De Uso

Installation (continued)

INSTALLING THE FAUCET

- Feed the hose (16) through the faucet pipe (3) and then the
faucet body (5), inserting the end with the small fitting (15) first.
- Insert the faucet pipe (3) into the faucet body (5) . Tighten the
set screw (4) with the supplied hex key (K) .
- Hand tighten the spray head (2) to the large fitting (1) of the
hose (16) . Push the hose (16) in so that the sprayer head (2)
aligns properly with the faucet pipe (3) .
- Unscrew the retaining ring (13) from the bottom of the faucet
body (5), ensuring that the rubber gasket (11), metal washer
(12) are removed with the retaining ring (13) .
- Install the faucet (B) through the hole in the sink (A) by feeding
the hose (16) through the hole, and placing the base of the
faucet on the sink (A) .
- From underneath, slide the rubber gasket (11), metal washer
(12), and retaining ring (13) over the free end of the hose (16) .
Slide them up to the exposed threaded section (10) of the faucet .
- Tighten the retaining ring (13) by hand until it is snug . Using a
wrench, tighten the assembly . Gently tighten the two screws on
the retaining ring (13) . Do not over tighten .
- Attach the end of the hose (16) with the small fitting (15) onto
the faucet outlet (14) and hand tighten . Using one wrench on
the nut of the faucet outlet (14) and another on the nut of the
hose (16), tighten the two ends together . Please note, tightening
the fittings with a single wrench may damage the faucet and
void the warranty .
- Install the counterweight (6) on the hose (16) about 2 in .
(50mm) from the bottom of the hose . This can be adjusted
based on your own requirements, but this is the normal location .
- The lever (7) and set screw (8) have been installed before
shipment . If the handle body (9) becomes loose over time,
remove the lever (7) and tighten the set screw (8) with the
supplied Hex Key (L) .
QK004
3
4
5
6
2 in
(50 mm)
15
16
12
1
2
7
8
9
10
11
12
13
14
15
16
14