Installing The Handle - Glacier bay HD65601-8004 Guía De Instalación Y Cuidado

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Installation (continued)
4
Removing the mounting kits
Remove the accessorize caps (G). Loosen the
set screws (H & K) with the Hex wrench
(Hex: 2.5mm, L) and remove the handles (I)
& handle seats (J).
Loosen the anges (M) from the valve bodys
(N & O). Adjust the rubber washers (P), metal
washers (Q) and mounting nuts (R) to the
bottom of valve bodys (N & O).
I
H
G
J
K
M
N
P
Q
R
6

Installing the handle

Place the handle seat (J) onto the right (cold)
ange (M) and the handle (I) onto the handle
seat (J). Place the set screw (K & H) into handle
seat (J) & handle (I) and tighten set screw (K & H)
with the Hex wrench (Hex: 2.5mm, L). Place the
accessorize cap (G) onto the handle (I).
Place the other handle onto the left (hot) valve
and install the same way.
G
L
H
I
J
K
M
O
P
Q
R
5
Installing the valve bodies
NOTE: The hot end valve is identi ed with a label.
From underneath the deck, insert the cold end
valve (O) with the rubber washer (P), metal
washer (Q) and mounting nut (R) through
the hole on the right (cold) side.
From above, thread the ange (M) onto the
valve body (O).
Tighten the mounting nut (R) using a basin
wrench, so that the ange (M) sits ush against
the nished deck surface.
Repeat this procedure for the hot end valve (N)
on the left (hot) side.
L
N
5
Please contact 1-855-HD-GLACIER for further assistance.
M
O
P
Q
R
G
L
H
I
J
L
K
M
HOMEDEPOT.COM
Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

1003181244

Tabla de contenido