Installing The Handle - Glacier bay HD461-7027D Guía De Instalación Y Cuidado

Installation (continued)
4
Removing the mounting kits
□
Loosen the anges (J) from the valve bodys
(K & L). Adjust the rubber washers (M), metal
washers (N) and mounting nuts (O) to the
bottom of valve bodys (K & L).
6

Installing the handle

□
Place the handle (G) onto the inverter (1). Place
the set screw (H) into handle (G) and tighten set
screw (H) with the Hex wrench (Hex: 2.5mm, I).
□
Place the other handle onto the left (hot) valve
and install the same way.
J
K
M
N
O
5
Installing the valve bodies
NOTE: The hot end valve is identi ed with a label.
□
From underneath the deck, insert the cold end
valve (L) with the rubber washer (M), metal
washer (N) and mounting nut (O) through
the hole on the right (cold) side.
□
From above, thread the ange (J) onto the
valve body (L).
□
Tighten the mounting nut (O) using a basin
J wrench, so that the ange (J) sits ush against
the nished deck surface.
□
Repeat this procedure for the hot end valve (K)
on the left (hot) side.
L
M
N
O
K
5
Please contact 1-855-HD-GLACIER for further assistance.
J
L
M
N
O
G
H
I
1
HOMEDEPOT.COM